2763 code after throttle actuator replacement

[Vinaypatel]

2763 code after throttle actuator replacement

Getting this code attached a picture below and cars EML coming on Everytime I clear it and reset, I fitted new throttle actuators from rebuild.org and see to be working, the code says dme VANOS valve inlet bank activation

[Assimilator1]

Left a plug off?

[Mtrizzyy]

Got the same issue here after installing rebuilt actuators any update??

[Vinaypatel]

Mine was battery issues

[KuRT.exe]

Originally Posted by Vinaypatel

Mine was battery issues

I have 2761 Inlet issues - but after cleaning/swapping banks realized they were popping up in conjuction with Low voltage errors. They also only occured during the initial start up cycle.

I would recommend checking this too.

[nutinmyexhaust]

Originally Posted by Vinaypatel

Mine was battery issues

Reviving a dead thread, mine shows the same after actuator replacement. How did you diagnose the battery issue and what was the fix? Thx

[Assimilator1]

Originally Posted by nutinmyexhaust

Reviving a dead thread, mine shows the same after actuator replacement. How did you diagnose the battery issue and what was the fix? Thx

Err, get the battery tested (as in at any garage with a battery tester).
Or you could go the more expensive route of a garage using ISTA (or equivalent) to test the battery.

[nutinmyexhaust]

Originally Posted by Assimilator1

Err, get the battery tested (as in at any garage with a battery tester).
Or you could go the more expensive route of a garage using ISTA (or equivalent) to test the battery.

Thanks, I’ll do that.