![]() |
|
|
| 05-09-2018, 07:04 PM | #1 |
|
Second Lieutenant
![]() 30
Rep 243
Posts |
Reduced engine power in limp mode, traction inactive
I was just driving and reduced engine power sign popped up, check engine light isnt always on with this, I can delete code and the reduced engine power light pops up with the traction off. Im not sure if its just an engine issue or something with the ABS or?
starts fine and drives fine just no power. I just pulled a code p2100 from it for throttle actuator, Im wondering if this is for sure it? 2009 hardtop vert M3 60k miles or so. I want the power back please, prius's passing me is messed up. Last edited by crawlin; 05-09-2018 at 07:24 PM.. |
| 05-09-2018, 08:23 PM | #2 | |
|
Lieutenant
![]() ![]() ![]()
234
Rep 502
Posts |
Quote:
Could be the throttle actuators.
__________________
![]() ![]() |
|
|
Appreciate
0
|
| 05-09-2018, 08:57 PM | #3 |
|
Brigadier General
![]()
1725
Rep 3,149
Posts
Drives: 2014 M5 6MT
Join Date: Nov 2013
Location: Massachusetts
|
Check to make sure the air filter is clean.
__________________
2014 M5 6MT
![]() |
|
Appreciate
0
|
| 05-10-2018, 08:14 AM | #4 |
|
BimmerPost Supporting Vendor
4324
Rep 3,023
Posts ![]()
Drives: 2011 E93 M3
Join Date: Nov 2014
Location: DFW, Texas
|
Get the actual BMW code for it not a generic OBD code. But its quite likely an issue with actuators.
|
|
Appreciate
0
|
| 05-13-2018, 10:25 AM | #5 | ||
|
Lieutenant
![]() ![]() ![]()
90
Rep 569
Posts |
Quote:
__________________
2015 K46 S1KRR
![]() 2008 E90 M3 ![]() |
||
|
Appreciate
0
|
| 05-13-2018, 02:27 PM | #7 |
|
Stop the hate, get a V8
3928
Rep 8,631
Posts |
Umm, the code says throttle actuators, so yes, it's probably those.
Check the BMW TIS (service manual) and see what the diagnostic steps are.
__________________
Now: 2017 Corvette Grand Sport, 2001 BMW Spec E46 race car, 2025 BMW M2
Past: 2011.5 M3 sedan ZCP |
|
Appreciate
0
|
| 05-13-2018, 06:48 PM | #8 |
|
Lieutenant
![]() ![]() ![]()
234
Rep 502
Posts |
If it is TA's it will start throwing you into limp mode intermittently. The best thing to do is do just replace them, as the gears slowly strip out because they are plastic. It is also possible to have a failure with the Siemens circuit boards.
I would suggest replacing them if it's your daily driver. I believe there are a few companies making rebuild kits to change the gears. If your interested in that YouTube has some videos for that and they also have some good DIY's. Use the YouTube guide for water pump and thermostat to take off the plenum. Then use the M3 post guide for the TA's. Lastly, if you want I have two TA's. One of them is still good and one was throwing a code. I made a thread about this before, so if you search you will find it. I'd be willing to sell them. However, one was good and the other was throwing a code. I dismantled both of them and found wearing on both TA's gears. If you wanted to buy them I'd sell them, it I think both would benefit from the gear rebuilds, which is like $150 or so on amazon for the new gears. Good luck and search through the posts here. I had the same issue and was able to complete the repair on my own using DIY here and YouTube.
__________________
![]() ![]() |
|
Appreciate
0
|
| 05-15-2018, 03:07 AM | #9 |
|
Banned
40
Rep 98
Posts |
Most likely Throttle Actuators. Just contact M Power Motorsports and buy Actuators from them. Will save you money and also a piece of mind vs just changing the gears. Majority of the times, changing gears doesn't work. Or if it does, it's just a very temporary fix.
|
|
Appreciate
0
|
Post Reply |
| Bookmarks |
|
|