|
|
03-18-2024, 12:18 AM | #1 |
Second Lieutenant
42
Rep 206
Posts |
O2 sensors?
Been getting this code, replaced all 4 o2 senors(Bosch FCP Euro), had an exhaust leak (replaced donut gaskets), replaced battery (Duralast AGM) and cleared codes. Did find Bank 1 post cat senor connection with a corroded pin due to old sensor missing green gasket (pics included), water was trapped between the connections when replaced but was able remove most of the corrosion. Drove 100 miles to see if codes would clear after but keeps returning with these codes:
Is there a fuse for all 4 sensors? If so where is it located??
__________________
2008 328I MB M-Sport E90
2011.5 E90 AW ZCP M3 1965 C-10 SWB (bagged) |
03-18-2024, 02:43 AM | #2 |
Lieutenant
692
Rep 426
Posts |
In the past I experienced a similar situation and replacing the DCT wiring harness (which includes the wiring for the 2 post CAT O2 sensors) along with the replacing my leaking DCT mechatronics harness o-ring removed the errors for all 4 O2 sensors simultaneously I was experiencing.
__________________
Last edited by Theodore; 03-25-2024 at 09:23 AM.. |
Appreciate
1
Snoball M342.00 |
03-18-2024, 11:21 AM | #3 | |
Second Lieutenant
42
Rep 206
Posts |
Quote:
__________________
2008 328I MB M-Sport E90
2011.5 E90 AW ZCP M3 1965 C-10 SWB (bagged) |
|
Appreciate
0
|
03-18-2024, 11:59 AM | #4 |
Lieutenant
692
Rep 426
Posts |
Yes to both, you can follow this DIY DCT mechatronics harness o-ring and the only step not shown is to disconnect the final connection point of the DCT/O2 sensor wiring harness from the relay box under the hood on the passenger side of the car which is self explanatory.
|
Appreciate
0
|
03-25-2024, 02:53 AM | #5 | |
New Member
74
Rep 22
Posts |
Quote:
|
|
Appreciate
1
Snoball M342.00 |
03-25-2024, 09:24 AM | #6 |
Lieutenant
692
Rep 426
Posts |
You are correct, I edited my original post.
|
Appreciate
1
Snoball M342.00 |
Post Reply |
Bookmarks |
|
|