|
|
01-17-2021, 06:54 PM | #222 |
Private
35
Rep 53
Posts |
Did you guys re-use the 14 Torx bolts when installing the pan or get new ones?
__________________
1997 Artic Silver E36 M3/4/5
2000 Sunlit Sand Nissan Maxima 5 SP 2011 Space Gray E82 N55 DCT. |
Appreciate
0
|
08-18-2021, 05:22 PM | #225 |
Lieutenant
59
Rep 418
Posts |
Jw what milage you have all done it at.
Hitting 83k no track days .... Just DD ... Plan doing it closer 90k mark if not 100k |
Appreciate
0
|
09-02-2021, 11:46 AM | #226 | |
.
2067
Rep 2,006
Posts
Drives: E92 M3
Join Date: Oct 2016
Location: MN
|
Quote:
Engine oil change, DCT fluid, diff fluid, and spark plugs replacement is the ultimate tune up for a smooth daily.
__________________
|
|
Appreciate
1
Mimmer58.50 |
09-02-2021, 09:31 PM | #227 |
Supreme Galactic Commander (one galaxy over...)
697
Rep 1,784
Posts |
I did new.
__________________
Best,
Andy '12 E82-PS2,Stoptechs,Clubsports+M3 bits,Accusump,Wagner DP+EVO III FMIC,ERCP,BMS Intake,Mason Strut Bar,Wedge Tune |
Appreciate
0
|
09-24-2021, 09:32 PM | #228 |
Private
23
Rep 52
Posts |
I had a shop do this service (should have DIYd it) and I'm not sure it was done correctly because my transmission now shifts like dog $#!7. What's the easiest way to reset the adaptations? What's the best way of verifying the fluid level (open the fill plug and see if any fluid will come out?
|
Appreciate
0
|
08-31-2022, 10:19 PM | #229 | |
Enlisted Member
9
Rep 40
Posts
Drives: 2008 E92 M3 DCT
Join Date: Jun 2021
Location: San Diego, CA
|
Quote:
I did this service, including the pan and filter, and now every time after starting from a complete stop, and only in 1st gear, (doesn't happen starting in 2nd gear) the car jerks forward as if I drove over a speed bump at 15 mph.. Then continues on driving fine, other than the fact it is also shifting hard... -like old crusty dog s%%t- hard You can reset the adaptations by putting key in ignition, and turning on ignition without starting the engine. With car powered on( gas Guage is up) hold down the gas pedal for 60 or so seconds, and with gas pedal still depressed, power off ignition and remove key. Let car sit for 2-3 minutes then start engine I know those directions definitely reset engine adaptations, not sure about transmission adaptations but worth a try |
|
Appreciate
0
|
10-06-2022, 01:33 PM | #230 |
Lieutenant
564
Rep 464
Posts |
Did this recently using the oil balancing procedure in ISTA. Just want to add that ISTA has a few menus that will read out the transmission temp, but the first couple pages' readings aren't updated live and will leave you there thinking the temp isn't going up even though you've got the engine on.
The first live updating temp reading will be when you get to the later menu that says there's max transmission cooling enabled. Once you've done the initial fill, just know to continue through the menus till you get to that page. |
Appreciate
0
|
02-08-2023, 03:27 PM | #231 |
Lieutenant
59
Rep 418
Posts |
jw do you need to replace this? my shop was rec to doing it..
BMW Dual Clutch Transmission Oil Pump Filter - Getrag 28107850148 https://www.fcpeuro.com/products/bmw...ag-28107850148 |
Appreciate
0
|
02-12-2023, 08:09 PM | #232 | |
Brigadier General
1475
Rep 3,040
Posts |
Quote:
__________________
INSTAGRAM: GORDON.M3
North American Mr12Volt Carplay/Android Auto Distributor DINAN | EVOSPORT | VAC | ARP | RD SPORT | NEEZ | EIBACH | CSF | IND | BILSTEIN | KLASSEN | BREMBO | ENDLESS | BBS | BPM SPORT | PROJECT MU | EVENTURI |
|
Appreciate
1
Mimmer58.50 |
03-18-2023, 07:30 PM | #233 |
Major
1816
Rep 1,250
Posts
Drives: 2009 E92 M3 Dakar Yellow II
Join Date: Oct 2021
Location: Edmonds, WA
|
Tip: never re-use the filter cap, the o-ring will eventually harden up and go flat. The pressure filter was leaking bad enough that I would drop about three tablespoons of fluid at startup and God only knows how much I dribbled all over creation before I parked it in October.
|
Appreciate
1
Harryc910.50 |
03-18-2023, 11:50 PM | #234 | |
Major
1206
Rep 1,152
Posts |
Quote:
|
|
Appreciate
0
|
10-17-2023, 06:36 AM | #235 |
Private
32
Rep 85
Posts |
Can someone please explain why people are changing the filters? Also, people are mentioning that there really is no distinguishable differences in shifting from before vs. after. My other question is related to the fluids color. Does the fluid color change really affect the quality of the fluid? The fact that someone swapped black fluids out after 2k miles of just putting in fresh pink colored fluids indicates that it’s normal for it to change color. On engine oil it turns brown because that means it’s doing it’s job and it doesn’t necessarily mean that the oil needs to be changed because it’s the filter which is the main part that needs to be changed. It just seems like over kill especially when all these Blackstone results are coming back virtually the same. I understand gaskets being changed with fresh fluid due to leaks, but why not just leave everything else and save some money? Someone mentioned here that there is a fine line between preventive maintenance and wasting money. It seems like people are having problems by even changing these parts out like weird shifting as someone has mentioned here and another thread. I’m at 123k miles and the car shifts fine. I feel like I’ll just end up with the same Blackstone results like everybody else lol
|
Appreciate
1
Harryc910.50 |
10-17-2023, 09:17 PM | #236 |
Major General
1607
Rep 8,074
Posts
Drives: 11 E90 M3 Individual
Join Date: Mar 2006
Location: Houston, TX
|
I just did the 3rd DCT service. I used the method here for the previous 2. Always had to add more fluid. I started to get a judder when going into reverse.
For this one, I cold fillled then used an Autel MX808 to do the oil balance and THEN I hot filled. I used every bit of 7 liters of fluid. Then I cleared the adaptive values. The car shifts much smoother and no judder when going into reverse. The bad news, the head on the fill plug came off. The fill plug is soft aluminum which prevents over-torqueing. Being this is the 4th time this plug has come out...should have been prepared. The drain plug is M18x1.5...I was able to get a volvo oil drain plug which is working. Waiting for the new plug to come in so I can replace it. Whoops. The fluid came out relatively clean with 30k on it. So I'll probably wait until the pan leaks to do another service.
__________________
2018 F30 320iX Melbourne Red
2011 E90 M3 Monte Carlo Blue 2004 E46 M3 Imola Red 2000 E36/7 Z3 Steel Blue |
Appreciate
0
|
10-17-2023, 09:23 PM | #237 | |
Major General
1607
Rep 8,074
Posts
Drives: 11 E90 M3 Individual
Join Date: Mar 2006
Location: Houston, TX
|
Quote:
I'm inclined to say do at least one service and then plan to do the next when you have a leak. You will have a leak at some point from either the mechatronics cover or oil pan. I tightened all of the bolts on my mechantroics cover once but it is leaking. I need to do rod bearings and engine mounts soon. So I'll tip the engine/trans back so I can replace the cover gasket. I might lose some oil but I'll just top it off. The oil pan is probably going to be leaking by the time it hits 130k to 140k...so it will be time for a service.
__________________
2018 F30 320iX Melbourne Red
2011 E90 M3 Monte Carlo Blue 2004 E46 M3 Imola Red 2000 E36/7 Z3 Steel Blue |
|
Appreciate
0
|
10-18-2023, 12:16 AM | #238 | |
Brigadier General
848
Rep 3,190
Posts |
Quote:
__________________
Current Mods:
2004 E46 M3cs JB/CSL 2010 E70 X5M AW/BLACK 2011 VW Golf R DSG White/Black IG: @060Motorsports |
|
Appreciate
0
|
10-18-2023, 12:38 PM | #239 |
Major General
1607
Rep 8,074
Posts
Drives: 11 E90 M3 Individual
Join Date: Mar 2006
Location: Houston, TX
|
No idea.
__________________
2018 F30 320iX Melbourne Red
2011 E90 M3 Monte Carlo Blue 2004 E46 M3 Imola Red 2000 E36/7 Z3 Steel Blue |
Appreciate
0
|
10-18-2023, 12:48 PM | #240 |
Major
1816
Rep 1,250
Posts
Drives: 2009 E92 M3 Dakar Yellow II
Join Date: Oct 2021
Location: Edmonds, WA
|
There used to be a company that made a viton gasket set for like 700 usd. Not sure if they are still available. I ended up just installing a Fall Line lower pan with a viton oring style gasket. The side cover is metal and should hold up better than the plastic pan but the rubber gasket is still a failure point. As is the top mechatronics cabling seal.
|
Appreciate
0
|
10-18-2023, 12:52 PM | #241 |
Major
1816
Rep 1,250
Posts
Drives: 2009 E92 M3 Dakar Yellow II
Join Date: Oct 2021
Location: Edmonds, WA
|
bigjae1976 you might want to order that fill plug from fcpeuro so you can get a fresh one every service. I’ve begun replacing that full plug and the motor oil drain plugs every service rather than risking breakage or stripping of the Allen sockets.
|
Appreciate
0
|
10-18-2023, 07:45 PM | #242 |
Major General
1607
Rep 8,074
Posts
Drives: 11 E90 M3 Individual
Join Date: Mar 2006
Location: Houston, TX
|
I got two, one spare.
__________________
2018 F30 320iX Melbourne Red
2011 E90 M3 Monte Carlo Blue 2004 E46 M3 Imola Red 2000 E36/7 Z3 Steel Blue |
Appreciate
1
spammysammich1816.00 |
Post Reply |
Bookmarks |
|
|