S65 Cylinder/Throttle Body Offset Dimension

[nsogiba]

Does anyone have the dimension of the throttle body offset/spacing between banks? See picture. I'm not looking for bore spacing, as that's equal on both banks at 98mm.



Figured I'd ask here before I go pulling off my plenum and measuring myself in case anyone has it kicking around or has seen a drawing/spec sheet online.

Thanks in advance!

[nsogiba]

Anyone?

[frankc]

I'm thinking that the offset should be the same as the connecting rod width at the crankshaft journal, since cylinders 1,5, 2,6, etc. occupy the same journal. I just finished replacing the rod bearings and still have the oil pan off, so I can measure this for you.

[nsogiba]

Originally Posted by frankc

I'm thinking that the offset should be the same as the connecting rod width at the crankshaft journal, since cylinders 1,5, 2,6, etc. occupy the same journal. I just finished replacing the rod bearings and still have the oil pan off, so I can measure this for you.

Fantastic. Yes, it should be the width of a rod journal, but unfortunately I don't have access to any of those. Thanks very much.

[nsogiba]

I was doing some additional digging in this this informative thread and found the following:

http://www.rcollins-home.org/photobu...=1596041750538