How easy/difficult is it to remove the leather insert portion of the door panels? I'd like to switch mine out to alcantara if it's not a huge pain in the ass.
5.8KVIEWS
5REPLIES
0APPRECIATES
02-27-2026LAST POST
Isn't it glued on or something? I've never tried to disassemble it, just swap the whole thing.
Might be better to use a peel n stick type of product?
Might be better to use a peel n stick type of product?
The leather is probably glued, but the piece it's glued to should be able to come out somehow. It's probably a bunch of plastic welds similar to how the pull handle is attached. The armrest would probably need to come out too, so it's probably more trouble than it's worth. I still might try it though lol
Well if you do decide to do it, it sounds like it will look dope
Bought a door panel to give this a try, and... I'm stuck.
So the door card structure is nothing more than a huge piece of molded cardboard. The insert is leather and padding wrapped around its own piece of cardboard. The board of the insert is flatly adhered to the board of the door card itself.
This is where I'm stuck. How do you unglue two pieces of paper product that's been flat glued without destroying one or the other? I've been using a heatgun and trim tools to pry around the edges (which will lift) but not sure how to get them unstuck in the center where I assume the glue is.
Now obviously lots of example here of custom inserts so there's a way. I don't know what it is though. Now this is a non-M e90 rear door with leather, but I doubt it's any different on the M.
Attached pic show through the speaker hole shows the two boards, adhered together.
So the door card structure is nothing more than a huge piece of molded cardboard. The insert is leather and padding wrapped around its own piece of cardboard. The board of the insert is flatly adhered to the board of the door card itself.
This is where I'm stuck. How do you unglue two pieces of paper product that's been flat glued without destroying one or the other? I've been using a heatgun and trim tools to pry around the edges (which will lift) but not sure how to get them unstuck in the center where I assume the glue is.
Now obviously lots of example here of custom inserts so there's a way. I don't know what it is though. Now this is a non-M e90 rear door with leather, but I doubt it's any different on the M.
Attached pic show through the speaker hole shows the two boards, adhered together.
Hi guys, i have an 93 m3, and im planning to rewrap my bamboo beige panels to a nice blue leather to match the custom floor mats and full seat covers, had to customize the headrest wrap to fit since its an M3.
I read somewhere that you have to grind down the melted tabs behind the panel to remove the leather insert, then you can carefully drill holes with a dremel or jewelers drill and reattach with metalpan head screws with right size threads and small plastic washers if theres play/looseness.
I read somewhere that you have to grind down the melted tabs behind the panel to remove the leather insert, then you can carefully drill holes with a dremel or jewelers drill and reattach with metalpan head screws with right size threads and small plastic washers if theres play/looseness.
