Performance Wheel V2 Wiring to CAS

Hey everyone,

I just tackled the install of the Performance Wheel V2 and just finished putting everything back together but the steering wheel doesn't come on! (Yes I've tried to power on with the two side buttons).

I'm a bit confused because the manual said to connect to CAS wiring at Pin 1 (Brown) and Pin 12 (Brown/Black) (30G) but on my CAS harness Pin 1 is actually red. Should I be tapping the thick brown wire instead?

Or alternatively, should I reroute the wiring to the JBE harness on the other side?

I also used Pico taps instead of the OEM taps because this is a used steering wheel so hopefully that didn't affect it either.

Would love to get this thing working

Thanks everyone.

Having the same issue, except mine wasn't used.

Also, I have DSC and ABS lights on

I installed a brand new V2 steering wheel on my buddies M3 using this DIY and I had 0 issues: http://www.m3post.com/forums/showthread.php?t=242963

Any solution to this issue, I have the same issue as the OP

Nevermind, I resolved this issue, I ended up wiring the wheel to the CAS, connecting the wires to pin 1 (red) and pin 12 (brown/black stripe) and it works fine.

Did the M Performance Electronic V2 Steering wheel install today and my CAS module PIN 1 wire was also red, just like mentioned in this thread. Pin 12 was brown/black.

speedster77 wrote

Did the M Performance Electronic V2 Steering wheel install today and my CAS module PIN 1 wire was also red, just like mentioned in this thread. Pin 12 was brown/black.

Did you have issues or everything came out ok? I'm about to install this myself

Vedubin01 wrote

speedster77 wrote

Did the M Performance Electronic V2 Steering wheel install today and my CAS module PIN 1 wire was also red, just like mentioned in this thread. Pin 12 was brown/black.

Did you have issues or everything came out ok? I'm about to install this myself

No issues once I labeled everything and followed the diy

speedster77 wrote

Vedubin01 wrote

speedster77 wrote

Did the M Performance Electronic V2 Steering wheel install today and my CAS module PIN 1 wire was also red, just like mentioned in this thread. Pin 12 was brown/black.

Did you have issues or everything came out ok? I'm about to install this myself

No issues once I labeled everything and followed the diy

Same, all is well here too! Loving the wheel!