|
|
|
KEEP M3POST ALIVE BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER LINK! |
Post Reply |
|
Thread Tools | Search this Thread |
10-12-2019, 07:52 PM | #1 |
Enlisted Member
4
Rep 37
Posts |
Hey everyone!
I recently purchased a set of Vossen x Work VWS 3's and I hadn't seen much of them so I wanted to share some pictures for anyone considering them. In the pictures in am not running any spacers and I'm on dinan lowering springs. The specs are as follows Front - 19x9 ET11 Rear - 19x10 ET23 Gloss Black Barrel + Lip Matte Gunmetal Face Tires are Toyo R88R Front 265/30 Rear 295/30 All in all I've been very happy with them! There is no rubbing while turning at all, a small amount of rubbing on the inside of the fender when I hit bumps though. I'd say they're a little heavier than I would've liked but it's only a cast 2 piece wheel, not a forged wheel. I had an issue with the valve stems that were provided to me by the vendor not clearing my stock brake calipers but I got around that on my own. The wheels were made, shipped, and delivered in about 11 weeks which was a long wait for wheels that in total cost about $4800 but they look amazing! I hope if anyone was considering these wheels this helps! |
Post Reply |
Bookmarks |
|
|