The Race Seat Fitment Thread

[DRLane]

Originally Posted by Tankslapper

Thank you DR Lane!

I asked the same question a while back and roastbeef set me straight with that link. Credit goes to him.

[spxxx]

I'm 6ft 175lbs and have run the following seats:

Sparco:

Circuit 2: One the best fitting of the seats I've run if you're okay with a halo, fits pretty tight and has similar bolster support to the Evo.

Evo S: Slightly tight but had a great balance of bolster support & comfort if you're driving on the street at all. I think a standard Evo would be perfect.

QRT-R: Pretty similar to the Evo but the bolster side support isn't as tall as I'd like.... Only noticed this after sitting in a Pro2000 (plan on switching to the Pro2000 soon).

Grid - lower bolsters but solid shoulder support. It's way too wide for my waist though (I run it as a passenger seat to accommodate bigger folks). Seems like a great option for anyone a bit more hefty than me. (36+ waist)

[omgzirra_exe]

Originally Posted by roastbeef

the rear mounting bolts on my sparco evo XL's was a fun time as well. the bottom of the seat is about 1/2" above the bolts... so you have to tighten just enough so you can adjust the mounts to mount the seat to the mounts, and then use and open ended wrench to torque the hex bolts down. like stated, oem bolts won't work because you can't get a torx bit on it.
tightening the inboard rear bolt is a real treat as well.

so EVO XL fit but QRT XL doesn't? lol

I've been trying to verify this for like a month hahah. cause I assumed the QRT replaced the evo?

[roastbeef]

Originally Posted by omgzirra_exe

so EVO XL fit but QRT XL doesn't? lol

I've been trying to verify this for like a month hahah. cause I assumed the QRT replaced the evo?

i don't know anything about the qrt replacing the evo XL, but the QRT-c is going to be made in a larger size in full carbon.

[omgzirra_exe]

Originally Posted by roastbeef

i don't know anything about the qrt replacing the evo XL, but the QRT-c is going to be made in a larger size in full carbon.

you know what I am dumb, they still do make the evo as the EVO XL QRT.

[e9x_m3]

Trying to figure out what seat rails work with Edirb 023s I picked up.. I've bought a set of Bride RO rails specific to the E92 that come with the mounts, rails and seat belt anchor but looking for something to tide me over while I wait for these to arrive..

They are bottom mount reclineable seats and the dimensions are..
405mm (width) x 260 mm (length) or 345mm (width) x 260 mm (length)

can anyone help me out?

[TR3S0R]

The guys that have used Brey Krause mounts on oem powersliders, was anyone able to keep the memory option functional?
I would like to keep this if possible, instead of doing the window switch mod.