|
|
05-18-2021, 07:25 AM | #2 |
Captain
483
Rep 647
Posts |
Pretty simple DIY. Most lips are pre drilled. Simple as remove bumper screws. Clean the lip and bumper thoroughly. Use alcohol wipes at the end. Double side tape the lip anywhere it will touch the bumper. Line it up just right. Once you push it up ...it's up! Put the screws back in and your done. I then use some magazine and stacked them under it to give it some more pressure on the tape. Let it sit overnight. Save a few hundred bucks.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|