BMW M3 Forum (E90 E92)

BMW Garage BMW Meets Register Today's Posts


Go Back   M3Post - BMW M3 Forum > E90/E92 M3 Technical Topics > Mechanical Maintenance: Break-in / Oil & Fluids / Servicing
 
Mporium BMW
Post Reply
 
Thread Tools Search this Thread
      08-22-2022, 12:13 PM   #1
uk215m3
New Member
18
Rep
19
Posts

Drives: e30 M3, e92 M3
Join Date: May 2022
Location: Qatar

iTrader: (0)

Engine vibration, 'noise' identification. Rod bearings?

Have this vibration just started today, can't say if it has been there before and getting worse, felt it first rather than heard anything.
Engine feels a little rough though. Wasn't like this yesterday.
91,000km Full dealer history. 12,000km oil changes.

On video phone was under the car on LH side behind wheel.
Revs to 3000rpm, 2500rpm, 3500rpm

Video:
https://www.facebook.com/davey.boy.3...96688382395997
Appreciate 1
      08-22-2022, 12:52 PM   #2
///M Power-Belgium
General
///M Power-Belgium's Avatar
Belgium
63327
Rep
24,658
Posts

Drives: ///M3-E92-DCT Silverstone II
Join Date: Jul 2012
Location: Belgium

iTrader: (0)

Quote:
Originally Posted by uk215m3 View Post
Have this vibration just started today, can't say if it has been there before and getting worse, felt it first rather than heard anything.
Engine feels a little rough though. Wasn't like this yesterday.
91,000km Full dealer history. 12,000km oil changes.

On video phone was under the car on LH side behind wheel.
Revs to 3000rpm, 2500rpm, 3500rpm

Video:
https://www.facebook.com/davey.boy.3...96688382395997
That noise Isn't the bearings or rod knock .
Must be something else .

Drive your your car on a lift and listen where the noise comes from.
__________________
"MAX VERSTAPPEN" IS THE 2021+2022+2023 F1 WORLD CHAMPION - #UnLeashTheLion

BPM DEV-Tune & DCT Software-Tune & Servotronic & coding ///Alpine HID Angeleyes ///Oem.exhaust mod.
Appreciate 0
      08-22-2022, 01:40 PM   #3
uk215m3
New Member
18
Rep
19
Posts

Drives: e30 M3, e92 M3
Join Date: May 2022
Location: Qatar

iTrader: (0)

Will try to get some time to put on a lift tmrw.
Also this vibration and associated noise can feel through the car and steering wheel. Driving and stationary
Didn't have anyone on hand to rev the car so i could listen and look either yet.
And engine mounts replaced about 5 months back.
Appreciate 0
      09-01-2022, 10:50 AM   #4
uk215m3
New Member
18
Rep
19
Posts

Drives: e30 M3, e92 M3
Join Date: May 2022
Location: Qatar

iTrader: (0)

Bit of a update. Not had much time to spend on the car.

Haven't found anything loose externally thats causing a resonance of anything like that as yet.


Pulled the oil filter for a look and did find some worrying metal flakes (pink circles). All are white metal with a mixture of magnetic and non-magnetic (larger pieces).

Also some fine 'dust' see pic with green circle.

And some valve cover paint, pic with blue circle.
Attached Images
     
Appreciate 0
      09-02-2022, 02:05 AM   #5
uk215m3
New Member
18
Rep
19
Posts

Drives: e30 M3, e92 M3
Join Date: May 2022
Location: Qatar

iTrader: (0)

zero glitter or anything else lurking in the oil filter housing either.
Attached Images
  
Appreciate 1
Ajolives922.00
      09-02-2022, 06:55 AM   #6
uk215m3
New Member
18
Rep
19
Posts

Drives: e30 M3, e92 M3
Join Date: May 2022
Location: Qatar

iTrader: (0)

So pulled the AC belt and the noise & vibration is virtually gone. Reconnected and its comes back.
Also fitted the new style low fuel pressure sensor. Engine did seem a lot smoother. Though didn't fully warm up or rev it past 2000 as was only at 60c

AC pulley has about 1-1.5mm of play in it. Same as the tension pulley, also about the same amount of play. To be honest though i am not sure if this is bad or normal for both parts.

But typically snapped the upper hose overflow pipe putting fan back in... doh
Appreciate 1
Ajolives922.00
      09-02-2022, 10:50 PM   #7
Scrippy
Lord Scrip
Scrippy's Avatar
United_States
1812
Rep
3,013
Posts

Drives: 2011 M3 Coupe
Join Date: Jan 2012
Location: LA,Ca

iTrader: (0)

Garage List
  [0.00]
2007 BMW 335i  [0.00]
Quote:
Originally Posted by uk215m3 View Post
So pulled the AC belt and the noise & vibration is virtually gone. Reconnected and its comes back.
Also fitted the new style low fuel pressure sensor. Engine did seem a lot smoother. Though didn't fully warm up or rev it past 2000 as was only at 60c

AC pulley has about 1-1.5mm of play in it. Same as the tension pulley, also about the same amount of play. To be honest though i am not sure if this is bad or normal for both parts.

But typically snapped the upper hose overflow pipe putting fan back in... doh
That overflow pipe is an asshole! If the AC belt was your issue just replace both belts tensioners and pulleys and be happy knowing you're good on those guys for a while now. Super easy job and good knowledge for water pump, oil filter housing gasket or whatever else is in the front of the motor down the road.
__________________
Appreciate 0
      09-05-2022, 02:17 AM   #8
omgzirra_exe
Lieutenant Colonel
omgzirra_exe's Avatar
United_States
1481
Rep
1,696
Posts

Drives: 4.4L M3, IS300
Join Date: Jun 2019
Location: Long Beach, CA

iTrader: (0)

A loose exhaust gasket can cause rattling noises aka replacing it should fix that and any driving issues.. shot engine mounts... is what you generally would feel on the steering wheel... you can tell if the engine is sitting closer to the belly pan more than usual also..
__________________
Build: ZillaSpec M3 N1 Build
M3Post Track General Discussion: Discord
#fakeGTS
Appreciate 0
      09-07-2022, 11:54 PM   #9
kyrix1st
Colonel
kyrix1st's Avatar
2362
Rep
2,362
Posts

Drives: G87 M2; E92M3 MT&DCT; M3 euro
Join Date: Sep 2014
Location: nyc

iTrader: (0)

Garage List
2004 BMW Z4  [0.00]
12000km OCI is not good for these engines. Go with 5000km or 1 year MAX, whichever hits the mark faster.
Your VANOS chain guide may be on its way out, supposedly common with high mileage motors. I would also get the RBs done ASAP, mine looked terrible around similar mileage and it's a relatively cheap insurance.
Maybe deansbimmer chime in on this one.

Quote:
Originally Posted by uk215m3 View Post
Have this vibration just started today, can't say if it has been there before and getting worse, felt it first rather than heard anything.
Engine feels a little rough though. Wasn't like this yesterday.
91,000km Full dealer history. 12,000km oil changes.

On video phone was under the car on LH side behind wheel.
Revs to 3000rpm, 2500rpm, 3500rpm

Video:
https://www.facebook.com/davey.boy.3...96688382395997
__________________
Pass me if you can.
Appreciate 0
Post Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 09:33 PM.




m3post
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
1Addicts.com, BIMMERPOST.com, E90Post.com, F30Post.com, M3Post.com, ZPost.com, 5Post.com, 6Post.com, 7Post.com, XBimmers.com logo and trademark are properties of BIMMERPOST