Glasses Tray (replaces ash tray) for E93 Installed

[Denny347]

I added the open cubby and hard-wired a USB charger to the factory lighter wiring. I then ran the USB into the glove box where I can hook up the phone to charge if I need to.

This is what I used
https://powerwerx.com/usbbuddy-power...device-charger

[Redd]

Nice thread! Can someone who's done the open cubby post a pic? I want to see how it looks with the rest of the center console.

[Denny347]

Originally Posted by Redd

Nice thread! Can someone who's done the open cubby post a pic? I want to see how it looks with the rest of the center console.

[Redd]

Thanks! That does look more practical than the tiny ciggie lighter cubby.

[ammar.sorour]

Originally Posted by tonylukes

Oh man, I prefer that one too. Instant buyers remorse lol.

could you please help me with it's measurement , I'm looking for 3d printing it and i don't know it's measurements

[DukeofAlexandria]

Originally Posted by ammar.sorour

could you please help me with it's measurement , I'm looking for 3d printing it and i don't know it's measurements

It’s….35$ my guy…

As someone who has a a makerbot replicator+, the amount of time you’ll take designing the piece and the PLA you’ll use will almost be even in my experience. You’ll easily go through half a spool so that’s 15-45$ depending on where you get and what brand and factor in the hours you’ll need to design, refine, and make adjustments.

Leaving out the fact that you might have to print multiples because your calculations are wrong….just buy the thing man hah.

-Duke