|
|
03-01-2019, 09:38 AM | #1 |
Major
901
Rep 1,044
Posts |
RDC Module in 2008
Hey, guys...
So, I had TPMS coded out last night, but still need to undo the RDC module. I was under the impression that the attached picture is the module (white connector), but I'm still getting a TPMS warning come up after unplugging it. Does the whole unit need to be removed from the vehicle as opposed to just being unplugged? Thanks! Sike! I found it. My trunk is kinda complicated to work on with the air ride stuff in there, so I didn't pull back the carpeting enough to see the RDC. Delete at will, moderators!
__________________
I did a lot of things to it. Last edited by Raek; 03-01-2019 at 10:02 AM.. |
03-01-2019, 09:42 AM | #2 |
Brigadier General
3943
Rep 3,988
Posts |
Did you following all the coding in this thread?
https://www.m3post.com/forums/showth...ght=FTM+coding If you don't do everything you will still get errors.
__________________
|
Appreciate
0
|
03-01-2019, 09:45 AM | #3 | |
Major
901
Rep 1,044
Posts |
Quote:
__________________
I did a lot of things to it. |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|