After a damaged e9X m3 bonnet.

[Rajvosa]

Anyone got a damaged bonnet they want to get rid of?
Pm me please. Cheers

[Jiren]

Originally Posted by Rajvosa

Anyone got a damaged bonnet they want to get rid of?
Pm me please. Cheers

I have a damaged E90 one. What do you need it for? BTW I'm in Canada, shipping will probably be too expensive

[Rajvosa]

want the bulge and vents section only. shipping might be much even just for that piece alone. but thanks anyways mate

[XIX]

Call wreckers bro, bound to be some

[perth1]

Hi,
What state are you in, and what is your plans with it? Just for moulding over. or to glue onto another bonnet?

Cheers,

[Rajvosa]

Originally Posted by perth1

Hi,
What state are you in, and what is your plans with it? Just for moulding over. or to glue onto another bonnet?

Cheers,

im in perth
yes planning to take bulge and vents and add onto a 1 series bonnet

[dmech1]

The bonnet is alloy and the 1 series is steel as far as I was told so it wont happen.

[phillay]

bog will make anything happen

[perth1]

Hi,
I spotted a white E92 M3 driving around with a damaged bonnet today, from Churchlands to Innaloo area. Not sure if the guy is on this forum? Obviously there will soon be a bonnet available at a panel shop somewhere in Perth area. It had a sharp dent almost at the headlight, near the grille.

You wouldn't need normal bog, you would need panel bonding compound (body glue), similar to the stuff that holds the carbon roof on the car. Plus perhaps some pop rivets to hold it down while the glue is curing. Of course some bog to even out the joint.
One problem is that you may also want to patch in, or cut out some of the reinforcements below the bonnet. Were you going to cut a hole to see the hump from below, or just stick it on top as a hidden cavity?
Cheers,