|
|
06-27-2012, 03:30 AM | #1 |
Private First Class
23
Rep 143
Posts |
Increased Emissions Service Engine Soon *code P2430*
Hi everyone,
Hope someone can help out. My car threw the lights at me and the dealer reset them and said they coud not get it to duplicate. It only happened once over 7 or so starts ... 2 Days later after about 20 starts or so it threw the lights again. Just spoke to dealer and asked what code it threw the first time and told me P2430. Can someone find what code that is? I searched for that specific code and series but could not find anything. I also searched the E90 forum ... Thanks, Denny
__________________
2009 E90 ///M3 SG Fox Red 6MT Slicktop, AA X-pipe w/straight pipes w/Eisenmann Sport, Dinan intake, AA Pulley, ZCP strut retro w/Dinan Stage III susp, BPM Stage II tune, Rear Fog LCI switch, BMW Edition Front & Side Grill/Gill, Thrust Arm Monoball, Solid Subframe Bushes, Black 19x9.5/10.5 APEX PS-7s, Vibra-Technics engine mounts, Auto Solutions shifter 20% throw, WPC treated Rod Bearings & AiB v4-Now, Not Wife approved!!
|
06-27-2012, 04:38 AM | #2 | |
Got my license back!
14
Rep 205
Posts |
Quote:
I would highly recommend you take this issue up with your Service Advisor and ask for them to rectify the problem opposed to simply clearing the fault codes.
__________________
aFe cold air intake system (stage 2) ▫ Agency Power cat delete/section 2 midpipes ▫ Agency Power exhaust system ▫ Beltronics STiR Plus ▫ BMW M style (ZHP) weighted short shift knob ▫ CIC iDrive ▫ Clutch pedal spring removal ▫ Coding ▫ Evolve-R tune ▫ Laser Interceptor ▫ LUX H8 V3 Angel Eyes ▫ pickyeater334 clutch stop ▫ Rear fog lights (2011 light control switch assembly) ▫ T3 Alpha laser gun protection ▫ Turner Motorsport power pulley kit
Last edited by DJDeez; 06-27-2012 at 05:42 AM.. Reason: Incorrect information provided |
|
Appreciate
0
|
06-27-2012, 05:03 AM | #3 | |
Private First Class
23
Rep 143
Posts |
Quote:
Where is the plug? On the sensor? Great info!!
__________________
2009 E90 ///M3 SG Fox Red 6MT Slicktop, AA X-pipe w/straight pipes w/Eisenmann Sport, Dinan intake, AA Pulley, ZCP strut retro w/Dinan Stage III susp, BPM Stage II tune, Rear Fog LCI switch, BMW Edition Front & Side Grill/Gill, Thrust Arm Monoball, Solid Subframe Bushes, Black 19x9.5/10.5 APEX PS-7s, Vibra-Technics engine mounts, Auto Solutions shifter 20% throw, WPC treated Rod Bearings & AiB v4-Now, Not Wife approved!!
|
|
Appreciate
0
|
06-27-2012, 05:43 AM | #4 |
Got my license back!
14
Rep 205
Posts |
My apologies in not proof-reading, I simply copied/pasted my original post and did not pay enough attention! Our vehicles do not have a Mass Air Flow Sensor (MAF) but rather a Manifold Absolute Pressure Sensor (MAP). I have updated my initial post, again I am sorry for any confusion caused on my behalf.
__________________
aFe cold air intake system (stage 2) ▫ Agency Power cat delete/section 2 midpipes ▫ Agency Power exhaust system ▫ Beltronics STiR Plus ▫ BMW M style (ZHP) weighted short shift knob ▫ CIC iDrive ▫ Clutch pedal spring removal ▫ Coding ▫ Evolve-R tune ▫ Laser Interceptor ▫ LUX H8 V3 Angel Eyes ▫ pickyeater334 clutch stop ▫ Rear fog lights (2011 light control switch assembly) ▫ T3 Alpha laser gun protection ▫ Turner Motorsport power pulley kit
|
Appreciate
0
|
06-27-2012, 06:49 AM | #5 | |
Private First Class
23
Rep 143
Posts |
Quote:
Still couple questions though ... Possibly the pressure sensor? or SAS pump? or is it looking like a MAP? Denny
__________________
2009 E90 ///M3 SG Fox Red 6MT Slicktop, AA X-pipe w/straight pipes w/Eisenmann Sport, Dinan intake, AA Pulley, ZCP strut retro w/Dinan Stage III susp, BPM Stage II tune, Rear Fog LCI switch, BMW Edition Front & Side Grill/Gill, Thrust Arm Monoball, Solid Subframe Bushes, Black 19x9.5/10.5 APEX PS-7s, Vibra-Technics engine mounts, Auto Solutions shifter 20% throw, WPC treated Rod Bearings & AiB v4-Now, Not Wife approved!!
Last edited by My Schnell; 06-27-2012 at 06:52 AM.. Reason: grammer |
|
Appreciate
0
|
07-04-2012, 02:26 PM | #6 |
Private First Class
23
Rep 143
Posts |
The dealer found the problem. The sensor on the hose, item 3, was the fualt.
03 SUCTION HOSE 1 11727838504 $124.92
__________________
2009 E90 ///M3 SG Fox Red 6MT Slicktop, AA X-pipe w/straight pipes w/Eisenmann Sport, Dinan intake, AA Pulley, ZCP strut retro w/Dinan Stage III susp, BPM Stage II tune, Rear Fog LCI switch, BMW Edition Front & Side Grill/Gill, Thrust Arm Monoball, Solid Subframe Bushes, Black 19x9.5/10.5 APEX PS-7s, Vibra-Technics engine mounts, Auto Solutions shifter 20% throw, WPC treated Rod Bearings & AiB v4-Now, Not Wife approved!!
|
Appreciate
2
Theodore668.50 Davisca4552207.50 |
10-19-2012, 10:33 AM | #7 |
Captain
69
Rep 957
Posts |
I had the same issue last May (dealer replaced the hose and sensor), and now, not even 5 months later I have "Increased emissions" message again, and the secondary air pump does not come on. What can be causing this?
|
Appreciate
0
|
10-21-2012, 08:41 AM | #10 |
Major General
4993
Rep 6,860
Posts |
|
Appreciate
0
|
10-30-2012, 02:37 PM | #12 |
Captain
338
Rep 923
Posts |
hi all, did any of you had to replace the throttle actuator? my dealer said they have replace that since the pressure sensor has been replaced and the code is still on.
Last edited by E90M3velocity; 10-31-2012 at 04:08 PM.. |
Appreciate
0
|
10-31-2012, 04:10 PM | #13 |
Captain
338
Rep 923
Posts |
Pulled codes 2738 and 2737 which shows the pressure sensor solenoid "F" control circuit not working properly, which i dont know why my dealer intends to replace both the throttle actuators (a grand per piece) to fix it.
|
Appreciate
0
|
06-04-2013, 12:12 PM | #14 |
First Lieutenant
18
Rep 396
Posts |
I just got these codes as well (P2432 & P2430). Had them cleared and the came back the next day. Can these codes be triggered by a dirty air filter? Is this suction hose that seems to be the problem in the front of the engine or near the firewall? Could it be a bad MAP sensor? Does anybody know where the MAP sensor is located?
|
Appreciate
0
|
06-04-2013, 04:17 PM | #15 |
Private First Class
23
Rep 143
Posts |
In my case, the suction hose was cracked. So the sensor was getting the wrong pressures. It's one unit too ...
__________________
2009 E90 ///M3 SG Fox Red 6MT Slicktop, AA X-pipe w/straight pipes w/Eisenmann Sport, Dinan intake, AA Pulley, ZCP strut retro w/Dinan Stage III susp, BPM Stage II tune, Rear Fog LCI switch, BMW Edition Front & Side Grill/Gill, Thrust Arm Monoball, Solid Subframe Bushes, Black 19x9.5/10.5 APEX PS-7s, Vibra-Technics engine mounts, Auto Solutions shifter 20% throw, WPC treated Rod Bearings & AiB v4-Now, Not Wife approved!!
|
Appreciate
0
|
06-05-2013, 05:16 PM | #17 |
Private First Class
23
Rep 143
Posts |
Right at the connection point to the sensor, forward side, I believe ...
__________________
2009 E90 ///M3 SG Fox Red 6MT Slicktop, AA X-pipe w/straight pipes w/Eisenmann Sport, Dinan intake, AA Pulley, ZCP strut retro w/Dinan Stage III susp, BPM Stage II tune, Rear Fog LCI switch, BMW Edition Front & Side Grill/Gill, Thrust Arm Monoball, Solid Subframe Bushes, Black 19x9.5/10.5 APEX PS-7s, Vibra-Technics engine mounts, Auto Solutions shifter 20% throw, WPC treated Rod Bearings & AiB v4-Now, Not Wife approved!!
|
Appreciate
0
|
07-10-2013, 07:14 PM | #19 |
*_*
808
Rep 3,160
Posts |
|
Appreciate
0
|
07-11-2013, 02:37 PM | #20 |
Private First Class
23
Rep 143
Posts |
Mine happened around 42K the first time ... About 4K later it came back but they did not tell me if it was the same issue.
__________________
2009 E90 ///M3 SG Fox Red 6MT Slicktop, AA X-pipe w/straight pipes w/Eisenmann Sport, Dinan intake, AA Pulley, ZCP strut retro w/Dinan Stage III susp, BPM Stage II tune, Rear Fog LCI switch, BMW Edition Front & Side Grill/Gill, Thrust Arm Monoball, Solid Subframe Bushes, Black 19x9.5/10.5 APEX PS-7s, Vibra-Technics engine mounts, Auto Solutions shifter 20% throw, WPC treated Rod Bearings & AiB v4-Now, Not Wife approved!!
|
Appreciate
0
|
11-13-2013, 01:39 PM | #21 |
Private
17
Rep 90
Posts
Drives: 08 e92 M3
Join Date: Feb 2012
Location: SoCal
|
I'm getting this error too p2430 p2432. I notice that on the realOEM picture posted above, item #3 suction hose, there isn't a sensor connected to the hose. Or is #11 the sensor? I looked up that part number and it seems like it's just an electrical plug? I'm going to try and fix this on my own since I hate having my wallet destroyed by the dealer. Does anybody know where exactly the sensor is?
|
Appreciate
0
|
11-13-2013, 02:34 PM | #22 |
Private First Class
23
Rep 143
Posts |
The dealer showed me the hose, sensor and crack. It is one unit, hose and sensor ... #3
__________________
2009 E90 ///M3 SG Fox Red 6MT Slicktop, AA X-pipe w/straight pipes w/Eisenmann Sport, Dinan intake, AA Pulley, ZCP strut retro w/Dinan Stage III susp, BPM Stage II tune, Rear Fog LCI switch, BMW Edition Front & Side Grill/Gill, Thrust Arm Monoball, Solid Subframe Bushes, Black 19x9.5/10.5 APEX PS-7s, Vibra-Technics engine mounts, Auto Solutions shifter 20% throw, WPC treated Rod Bearings & AiB v4-Now, Not Wife approved!!
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|