|
|
01-22-2021, 07:02 PM | #1 |
Captain
366
Rep 860
Posts |
ABS/Wheel speed sensor connector help
What's the trick to getting the crumbling connector apart in one piece for the ABS / Wheel sensors?
I have a 005DC3 code which points to the right rear from what I can see. I was looking for tips as I know the brake pad sensor connectors won't come apart on this car and I'm sure these are just as bad or worse as they are original on an 09. I don't feel like splicing a new socket into the harness so I was hoping someone had some tips or tricks.
__________________
|
01-24-2021, 01:21 AM | #2 |
Captain
366
Rep 860
Posts |
All done. The connector actually released without any issue. The plastic is a much better material than the pad sensor connector. Wish they both were this good.
Good news is I don't need a new wheel bearing (yet). ABS fault is gone. DSC fault is gone and works properly after trying to throw the rear around a few corners. Uphill assist if fixed. Cruise control works. I didn't even have to clear the error. It reset after about 20 feet of driving. So for anyone with my above error code and issues, I would start with the sensor first.
__________________
Last edited by TX; 01-24-2021 at 04:30 AM.. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|