Alex Alpine ECU Tune

wyatth · 03-17-2020, 05:18 PM

Quote:

Originally Posted by wyatth

Hey Alex, it possible to run your Euro MDM, Servotronics, DCT, coding, etc. with another DME tune (either OEM 240E or otherwise)? Or are some of these other software features integrated into the engine tune?

Alex@Alpine · 03-17-2020, 11:37 PM

Quote:

Originally Posted by wyatth

Hey Alex, it possible to run your Euro MDM, Servotronics, DCT, coding, etc. with another DME tune (either OEM 240E or otherwise)? Or are some of these other software features integrated into the engine tune?

Servotronics is part of the motor tune.

All else can be done separately sure no problem

-240E is the factory software level.

Wally1552 · 03-26-2020, 11:01 PM

If I need to reflash a tune map after going back to stock, should I still run the flash first file or can I go straight to the engine tune.map? Thanks

s0ldats · 03-27-2020, 12:40 AM

can someone explain the need to start /stop the motor for 5 seconds, twice after a flash?

Alex@Alpine · 03-27-2020, 01:31 AM

Quote:

Originally Posted by s0ldats

can someone explain the need to start /stop the motor for 5 seconds, twice after a flash?

Some have bouncy idle after a flash. Doing two starts helps set idle.

Wally1552 · 03-27-2020, 06:10 AM

Quote:

Originally Posted by Alex@Alpine

Some have bouncy idle after a flash. Doing two starts helps set idle.

Hi Alex,
I still experienced this after the two starts and when at a stop light my idle is around 900rpm. Will that eventually go away?

Besides that, the tune has been great. It really has improved throttle response and low end has improved.

Alex@Alpine · 03-27-2020, 09:33 AM

Quote:

Originally Posted by Wally1552

Quote:

Originally Posted by Alex@Alpine

Some have bouncy idle after a flash. Doing two starts helps set idle.

Hi Alex,
I still experienced this after the two starts and when at a stop light my idle is around 900rpm. Will that eventually go away?

Besides that, the tune has been great. It really has improved throttle response and low end has improved.

Idle isn't touched by the tune at all or controlled by the tune. If you are confusing you having a higher idle with a bouncy idle, the idle will fluctuate between 600 to 900 on these cars as you drive them.

Bouncy idle is when the car feels like it is going to stall.

Wally1552 · 03-27-2020, 12:11 PM

Quote:

Originally Posted by Alex@Alpine

Idle isn't touched by the tune at all or controlled by the tune. If you are confusing you having a higher idle with a bouncy idle, the idle will fluctuate between 600 to 900 on these cars as you drive them.

Bouncy idle is when the car feels like it is going to stall.

Thanks for the clarification

wyatth · 03-27-2020, 01:20 PM

Hi Alex, one other follow up - is your GTS DCT tune the same as factory GTS, or modified by you? If the latter, how so? Thanks!

Alex@Alpine · 03-27-2020, 07:20 PM

Quote:

Originally Posted by wyatth

Hi Alex, one other follow up - is your GTS DCT tune the same as factory GTS, or modified by you? If the latter, how so? Thanks!

Wrong thread. You can google it or find the large DCT thread it's all explained

Tut4u2 · 04-04-2020, 09:30 PM

I will throw my review in here as well. Alex is the real deal, great to work with, and very professional. I purchased my cable on Valentine's Day and to my surprise, I had a tracking number a couple of hours later. Furthermore, it was express shipping which I wasn't expecting at all.

I followed the instructions in his email, loaded his tune, and the car fired up without any issues. A couple of days later, I got a number of codes which I thought were tune related. After a number of emails back and forth, he assured me that it was not tuning related and that there was an underlying issue. Sure enough, I tore the car apart, found that one of air pump hoses came loose, and that was the cause of the codes.

I can't compare his tune versus another tuners, but the car runs well and I have not experienced any issues. Lastly, I requested another tune a couple of weeks after my initial tune, and he sent it within a day of my request.

If you're on the fence, I would go with him. I'm picky about my tuners as I tune my own cars which isn't an option on this platform and I didn't want to blindly trust an OTS tune, but I have been pleased and grateful that I choose him. His communication and response time is phenomenal. Lastly, you cannot beat his price. I will throw up a dyno graph once I get the car on the dyno after the current situation passes.

gillara · 04-07-2020, 01:53 PM

Hi Alex,

Will you be having a COVID sale? or any sales in the near future? thanks!

Nisfro98 · 04-08-2020, 03:56 PM

Can some explain how enable and disable the valet feature?

DRLane · 04-08-2020, 04:12 PM

Quote:

Originally Posted by Nisfro98

Can some explain how enable and disable the valet feature?

Valet is separate tune - Can't run it in conjunction with standard stage 1 / 2.

Route 16 · 04-14-2020, 11:38 AM

Alex, if I place my stock primary cats temporarily to pass visual inspection (I'm in Germany). Do I have to reflash back to stock? Will I have a service engine soon light?

I'm currently on your stage 2 file tune from 2018. Probably driving 50 miles total through this ordeal.

statik · 04-14-2020, 01:25 PM

Quote:

Originally Posted by Route 16

Alex, if I place my stock primary cats temporarily to pass visual inspection (I'm in Germany). Do I have to reflash back to stock? Will I have a service engine soon light?

I'm currently on your stage 2 file tune from 2018. Probably driving 50 miles total through this ordeal.

it would be fine to use the stage 2 file assuming you don’t drive the car hard, otherwise just flash back to stage 1 to avoid any issues.

Route 16 · 04-16-2020, 01:07 AM

Quote:

Originally Posted by statik

it would be fine to use the stage 2 file assuming you don’t drive the car hard, otherwise just flash back to stage 1 to avoid any issues.

awesome, not it'll be babied, no hard driving during the swap

//steve\\ · 04-17-2020, 09:33 AM

Curious, with a stage2 tune running a primary cat deletes on an otherwise stock engine is it possible to get all but 1 readiness monitor set? I assume the o2 will not reach readiness with the primaries deleted.

strokemycocktus · 04-17-2020, 11:34 PM

I also wanted to know if a stage 2 tune is ok for an xpipe such as ESS with 200cpsi high flow cats in the primary section? Maybe there's a special option for such setup? I heard that running a catless tune is a bad idea and can melt the cats.

Alex@Alpine · 04-18-2020, 03:33 AM

Quote:

Originally Posted by strokemycocktus

I also wanted to know if a stage 2 tune is ok for an xpipe such as ESS with 200cpsi high flow cats in the primary section? Maybe there's a special option for such setup? I heard that running a catless tune is a bad idea and can melt the cats.

Stage 2 is fine, just no burbles.

Powashiftin · 04-18-2020, 07:39 AM

Alex@alpine any updates to your tunes? I purchased your tune last year. Thanks.

strokemycocktus · 04-19-2020, 01:12 AM

Quote:

Originally Posted by Alex@Alpine

Quote:

Originally Posted by strokemycocktus

I also wanted to know if a stage 2 tune is ok for an xpipe such as ESS with 200cpsi high flow cats in the primary section? Maybe there's a special option for such setup? I heard that running a catless tune is a bad idea and can melt the cats.

Stage 2 is fine, just no burbles.

Ok thanks! I'd never get burbles for this car lol.
Now I'm just waiting for the next promo!

03-26-2020, 11:01 PM	#1015
Wally1552 First Lieutenant 122 Rep 334 Posts Drives: 135i Join Date: Jun 2009 Location: HI iTrader: (0)	If I need to reflash a tune map after going back to stock, should I still run the flash first file or can I go straight to the engine tune.map? Thanks
	Appreciate 0 Quote

03-27-2020, 12:40 AM	#1016
s0ldats First Lieutenant 54 Rep 334 Posts Drives: 2011 E90 M3 stripper Join Date: Aug 2019 Location: socal iTrader: (0)	can someone explain the need to start /stop the motor for 5 seconds, twice after a flash?
	Appreciate 0 Quote

03-27-2020, 01:20 PM	#1021
wyatth Colonel 3549 Rep 2,824 Posts Drives: E90 ZCP Join Date: Dec 2007 Location: Bay Area iTrader: (0)	Hi Alex, one other follow up - is your GTS DCT tune the same as factory GTS, or modified by you? If the latter, how so? Thanks!
	Appreciate 2 s0ldats53.50 Milas29.50 Quote

04-04-2020, 09:30 PM	#1023
Tut4u2 Second Lieutenant 235 Rep 258 Posts Drives: 1M3 Conversion Join Date: Aug 2019 Location: Washington, DC iTrader: (2)	I will throw my review in here as well. Alex is the real deal, great to work with, and very professional. I purchased my cable on Valentine's Day and to my surprise, I had a tracking number a couple of hours later. Furthermore, it was express shipping which I wasn't expecting at all. I followed the instructions in his email, loaded his tune, and the car fired up without any issues. A couple of days later, I got a number of codes which I thought were tune related. After a number of emails back and forth, he assured me that it was not tuning related and that there was an underlying issue. Sure enough, I tore the car apart, found that one of air pump hoses came loose, and that was the cause of the codes. I can't compare his tune versus another tuners, but the car runs well and I have not experienced any issues. Lastly, I requested another tune a couple of weeks after my initial tune, and he sent it within a day of my request. If you're on the fence, I would go with him. I'm picky about my tuners as I tune my own cars which isn't an option on this platform and I didn't want to blindly trust an OTS tune, but I have been pleased and grateful that I choose him. His communication and response time is phenomenal. Lastly, you cannot beat his price. I will throw up a dyno graph once I get the car on the dyno after the current situation passes. Last edited by Tut4u2; 04-12-2020 at 10:04 PM..
	Appreciate 4 Alex@Alpine1303.00 MP0W3RD125.00 Milas29.50 91foxbody47.00 Quote

04-07-2020, 01:53 PM	#1024
gillara Private First Class 19 Rep 102 Posts Drives: 2011 E90 M3 Comp Join Date: Dec 2019 Location: Sacramento, California iTrader: (0)	Hi Alex, Will you be having a COVID sale? or any sales in the near future? thanks!
	Appreciate 0 Quote

04-08-2020, 03:56 PM	#1025
Nisfro98 Private First Class 51 Rep 170 Posts Drives: Mazda3 Join Date: Aug 2019 Location: KY iTrader: (0)	Can some explain how enable and disable the valet feature?
	Appreciate 0 Quote

04-14-2020, 11:38 AM	#1027
Route 16 I got lei'd 844 Rep 7,593 Posts Drives: '10 E90 M3 Join Date: Sep 2011 Location: Dark Side of the Moon iTrader: (62)	Alex, if I place my stock primary cats temporarily to pass visual inspection (I'm in Germany). Do I have to reflash back to stock? Will I have a service engine soon light? I'm currently on your stage 2 file tune from 2018. Probably driving 50 miles total through this ordeal.
	Appreciate 0 Quote

04-17-2020, 09:33 AM	#1030
//steve\\ Major $//steve\\'s Avatar$ 1074 Rep 1,027 Posts Drives: 2012 E92 M3 Join Date: May 2012 Location: Atlanta, GA iTrader: (2)	Curious, with a stage2 tune running a primary cat deletes on an otherwise stock engine is it possible to get all but 1 readiness monitor set? I assume the o2 will not reach readiness with the primaries deleted.
	Appreciate 0 Quote

04-17-2020, 11:34 PM	#1031
strokemycocktus Lieutenant 119 Rep 423 Posts Drives: E92 M3 6MT ZCP Join Date: Jul 2016 Location: Europe iTrader: (0)	I also wanted to know if a stage 2 tune is ok for an xpipe such as ESS with 200cpsi high flow cats in the primary section? Maybe there's a special option for such setup? I heard that running a catless tune is a bad idea and can melt the cats. __________________ strokemycocktus
	Appreciate 0 Quote

04-18-2020, 07:39 AM	#1033
Powashiftin Captain 171 Rep 957 Posts Drives: E92 M3 Join Date: Apr 2010 Location: NJ iTrader: (2)	Alex@alpine any updates to your tunes? I purchased your tune last year. Thanks.
	Appreciate 0 Quote