Brushed BBS LM Floss Design build 20's w/ Toyo Proxes T1 Sport

[Kenyon]

Selling a set of newly refinished brushed face BBS LM's built by Floss Design wrapped & in brand new Toyo Proxes T1 Sport tires.
-Faces are brushed finished and clear coated. Also had the BBS imprints painted in red to compliment the red Center caps.
-Barrels are original BBS 9 and 10 inch wide pieces with the lips polished and clear coated.
-Brand new Red Center caps.
-Brand new BBS valve stems & caps (opt to not use TPMS)
-Brand new hardware nuts and bolts. Used larger M8 bolts instead of standard M7 bolts for a better look.
-New Toyo Proxes T1 Sport tires
Specs:
Front- 20 x 9 et 15 5x120
245/30/20
Rear- 20 x 10 et 11 5x120
275/30/20
This offset was achieved by using a more aggressive face to match up with the 10 inch barrel where Floss Design measured it out to 20x10 et11.
The stance is very close to the aggressive 20 x 10.5 et 15 rear LM's that some guys are running.
If you plug the numbers on willtheyfit.com my rears will be less aggressive by 2.3mm.
Mounted and road force balanced. Installed on my car and took some pics. Put no more than 20 miles.
Ended up taking them off & putting my car to stock to sell.
Currently available for pick up in NYC area from now till December.
I'll be relocating to Los Angeles in December so if it does not sell by then, it's coming to LA with me & will be available to SoCal fellas.
If it doesn't sell than I'll most likely have Floss rebuild new rear barrels to fit my F80 since they run a much less aggressive offset in the rear.
Asking $5500 pick up

[Kenyon]

Pics

[GRUESOM3]

Nice wheels good luck with sale

[0-60Motorsports]

Stunning LM's. GLWS

[GRUESOM3]

Was wondering what faces were used in the rear? Is it possible that they swapped fronts with rears to achieve those offsets?

I have 20's also and would like to know if you can give us the stamp numbers of the faces of front and rear