RDC Module in 2008

Raek · 03-01-2019, 09:38 AM

Hey, guys...

So, I had TPMS coded out last night, but still need to undo the RDC module. I was under the impression that the attached picture is the module (white connector), but I'm still getting a TPMS warning come up after unplugging it.

Does the whole unit need to be removed from the vehicle as opposed to just being unplugged?

Thanks!

Sike! I found it. My trunk is kinda complicated to work on with the air ride stuff in there, so I didn't pull back the carpeting enough to see the RDC.

Delete at will, moderators!

tdott · 03-01-2019, 09:42 AM

Did you following all the coding in this thread?

https://www.m3post.com/forums/showth...ght=FTM+coding

If you don't do everything you will still get errors.

Raek · 03-01-2019, 09:45 AM

Quote:

Originally Posted by tdott

Did you following all the coding in this thread?

https://www.m3post.com/forums/showth...ght=FTM+coding

If you don't do everything you will still get errors.

Had it done by BPM sport, so I know it's all good. I think I may just have the wrong plug unplugged.

03-01-2019, 09:38 AM	#1
Raek Major 901 Rep 1,044 Posts Drives: 08 M3, '17 Macan GTS Join Date: Nov 2014 Location: New York iTrader: (1)	RDC Module in 2008 Hey, guys... So, I had TPMS coded out last night, but still need to undo the RDC module. I was under the impression that the attached picture is the module (white connector), but I'm still getting a TPMS warning come up after unplugging it. Does the whole unit need to be removed from the vehicle as opposed to just being unplugged? Thanks! Sike! I found it. My trunk is kinda complicated to work on with the air ride stuff in there, so I didn't pull back the carpeting enough to see the RDC. Delete at will, moderators! __________________ I did a lot of things to it. Last edited by Raek; 03-01-2019 at 10:02 AM..
	Appreciate 0 Tweet Quote

03-01-2019, 09:42 AM	#2
tdott Brigadier General 3943 Rep 3,988 Posts Drives: M3 Join Date: Nov 2010 Location: South FL / 6ix iTrader: (4)	Did you following all the coding in this thread? https://www.m3post.com/forums/showth...ght=FTM+coding If you don't do everything you will still get errors. __________________ N/A S65 Headers Before/After Dyno Results
	Appreciate 0 Quote