|
|
02-18-2019, 02:10 PM | #1 |
Enlisted Member
6
Rep 47
Posts |
Fault Codes After Replacing Throttle Actuators
Hey Everyone,
I just replaced my throttle actuators and after clearing the codes it pulled up a few new ones that I never saw before. I tried doing research but cant find a answer that really explains what they are or what could be causing it. Any help would be appreciated. |
02-18-2019, 10:57 PM | #3 |
New Member
3
Rep 8
Posts |
I got the same code (2765/present Valve , inlet, bank 2, activation) and after taking everything off again I doubled checked all the wiring and the wire connection on Bank 2 Vano Solenoid wasn't fully plugged in! After putting everything back I erased the code and hasn't came back on yet! This should be your first Diagnostic! Hope it helps
|
Appreciate
0
|
02-22-2019, 08:47 AM | #4 |
Enlisted Member
6
Rep 47
Posts |
do you know exactly which wire that is so I know exactly what to check even though I am going to check them all I want to make sure that one is 100% snug
|
Appreciate
0
|
02-22-2019, 10:28 AM | #5 | |
Enlisted Member
6
Rep 47
Posts |
Quote:
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|