StudioRSR E93 installation instructions

[db2000]

I’ve search here and YT as well as asking RSR for instructions for E93 specifically with no luck. I’m basically getting ghosted since last week from StudioRSR. It’s very frustrating they would sell a cage and ship it with zero instructions. Anyway, I need the exact drilling and bolting locations. It’s locked up in the car and I think I see where it goes but there’s two plates with the mounting hardware that are specified which posts they got with and how to use them. It’s different from e92 so not sure why people post “e90 or e9x cage”. The e93 mounts differently.


*edit
Nick at StudioRSR finally responded and provided the instructions below:

[db2000]

- Remove driver/passenger seats
- Remove all the side bolsters for the rear seat sections
- You will gain access to the rear wheel well sections
- Install main hoop and connect the rear section together
- Connect both rear and main hoop together "using the 4 black button head bolts"
- Mark your 3 holes for each side on the rear section as it sits flush on each side to the wheel well for the rear section
- with the cage mocked up , you will need to slit the carpet of the main flooring for the main hoop as the metal needs to be flush to the chassis floor board
- Remove main hoop
- Drill out the holes you marked for the main hoop
- Install the sandwich plates provided with the supplied hardware
- Re install main hoop, Connect main and rear section "using the 4 black bolts"
- Bolt down the main hoop fully "using the 6 grade 8 bolts & 6 washers"
- Bolt down the rear section fully
- Re install passenger & driver seat


***There is no need to remove front seats, it’s a fucking convertible.

[roastbeef]

are you sure it will fit an e93?