|
|
03-27-2017, 07:29 PM | #1 |
Major
314
Rep 1,017
Posts
Drives: 2010 E92 M3 6MT
Join Date: Apr 2013
Location: Mississippi
|
Had few codes thrown and cyl 1 misfire detection last week. Put new coil pack in cyl 1 and took for a spin, now have these poping up.
Thoughts? Timing? Injectors? Fuel Rails? DME? 1. 273E Lambda sensor terminal stage heating VKAT bank 1 2. 2741 Lambda sensor heating control diagnostic VKAT bank 2 3. 2740 Lambda sensor heating control diagnostic VKAT bank 1 4. 274F Lambda sensor error Nernst cable VKAT bank 2 5. 274E Lambda sensor error Nernst cable VKAT bank 1 6. 2749 Lambda probe Diag. viaATIC42-device VKAT bank 2 Discriptions I looked up: 273E Signal temper.sensor exhaust1 2741 Pedal-travel2 permanently (Voltage supply?) 2740 Pedal-travel1 permanently (Voltage Supply?) 274F Misfire, Checksum failure, service rel. 274E Misfire detection, Checksum failure (All Cyl?) 2749 Misfire detection cyl Both pre cat o2 sensors only have 2k on them "replaced them twice recently" Spark plugs only have 3k on them. 62k on coil packs 32k on ESS 625 white fuel injectors Built stroker engine Last edited by squartus; 03-28-2017 at 09:41 AM.. |
03-29-2017, 05:27 AM | #2 |
Captain
68
Rep 614
Posts |
sounds like bad O2 sensors
|
Appreciate
0
|
03-29-2017, 11:15 AM | #3 |
Major
314
Rep 1,017
Posts
Drives: 2010 E92 M3 6MT
Join Date: Apr 2013
Location: Mississippi
|
Both precats have been replaced twice in the past 3k.
__________________
4.4L LC stroker/ESS VT2-625/Volk te37 sl's/AA exhaust/DSS Carbon Fiber driveshaft/ARH Headers.. etc |
Appreciate
0
|
03-29-2017, 11:41 AM | #4 |
PAZUZU
545
Rep 2,058
Posts
Drives: '15 M4
Join Date: Sep 2013
Location: San Antonio, TX
|
i'm only guessing because of the 'pedal travel' description but is it similar codes for throttle actuators?
__________________
2009 M3 DCT ESS625+ SOLD 2015 M4 BSM/Silverstone F4LCON @texasMclub IG @jagemoets |
Appreciate
0
|
03-29-2017, 11:55 AM | #5 |
Major
314
Rep 1,017
Posts
Drives: 2010 E92 M3 6MT
Join Date: Apr 2013
Location: Mississippi
|
Weird thing is its not going into limp mode, no reduced power etc.
__________________
4.4L LC stroker/ESS VT2-625/Volk te37 sl's/AA exhaust/DSS Carbon Fiber driveshaft/ARH Headers.. etc |
Appreciate
0
|
03-29-2017, 11:59 AM | #6 | |
PAZUZU
545
Rep 2,058
Posts
Drives: '15 M4
Join Date: Sep 2013
Location: San Antonio, TX
|
Quote:
sorry i'm no help, did you buy OEM O2s when you replaced them?
__________________
2009 M3 DCT ESS625+ SOLD 2015 M4 BSM/Silverstone F4LCON @texasMclub IG @jagemoets |
|
Appreciate
0
|
03-29-2017, 12:05 PM | #7 |
Major
314
Rep 1,017
Posts
Drives: 2010 E92 M3 6MT
Join Date: Apr 2013
Location: Mississippi
|
Got bosh both times, had to replace them about 20k ago as well, got bosh then as well.
__________________
4.4L LC stroker/ESS VT2-625/Volk te37 sl's/AA exhaust/DSS Carbon Fiber driveshaft/ARH Headers.. etc |
Appreciate
0
|
04-04-2017, 04:36 PM | #8 |
Major
314
Rep 1,017
Posts
Drives: 2010 E92 M3 6MT
Join Date: Apr 2013
Location: Mississippi
|
Looks like its a voltage issue from the DME, tracking down to see if its wiring or the DME itself.
Will update incase anyone else gets same codes, might also explain why I was eating 02 sensors.
__________________
4.4L LC stroker/ESS VT2-625/Volk te37 sl's/AA exhaust/DSS Carbon Fiber driveshaft/ARH Headers.. etc |
Appreciate
0
|
05-05-2017, 12:03 PM | #10 |
PAZUZU
545
Rep 2,058
Posts
Drives: '15 M4
Join Date: Sep 2013
Location: San Antonio, TX
|
i'm hoping it was a bad battery or the cable that is under the recall campaign. I haven't seen an update from Shady1 either.
__________________
2009 M3 DCT ESS625+ SOLD 2015 M4 BSM/Silverstone F4LCON @texasMclub IG @jagemoets |
Appreciate
0
|
05-05-2017, 05:50 PM | #11 |
Major
314
Rep 1,017
Posts
Drives: 2010 E92 M3 6MT
Join Date: Apr 2013
Location: Mississippi
|
It required a new DME, zero codes now. Tried everything else for like 2 weeks just to make sure but no dice.
__________________
4.4L LC stroker/ESS VT2-625/Volk te37 sl's/AA exhaust/DSS Carbon Fiber driveshaft/ARH Headers.. etc |
Appreciate
0
|
03-11-2019, 08:23 PM | #13 |
Private
13
Rep 50
Posts |
Guys,
Have a look at my last post on this thread, might help as it was all getting too coincidental O2 Sensor Fault Codes Edited: Original post had the wrong link Last edited by Snappa2000; 04-17-2019 at 12:34 AM.. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|