DIY: Disable TPMS and Enable FTM without sensors

[tryingtobebest]

Hey, guys, sorry to bring up an old thread.
Im very good with coding, was following steps in this thread and was able to code/opt out from stupid FTM system with success (2008 US E90 in Canada, NO Nav), but now i have issue with "DSC" module where i CANNOT, in any way, clear neither front or rear pad sensor errors (worn through). I have IstaD ready and it refuse to clear this, before manipulation with edited FA and coding DSC the pad sensors were good!

I cannot for the life of me find out why some people say one have to add option $265 to VO. Can someone clarify what is this option is, i cant decode it... And i did few Canadian (never came with TPMS, only FTM) E90 vins and that line is never there....

Also, do i really need to default code NFRM? Some say yes some let it slip....

[///Mobbin]

For my front and rear pad sensors I cut them off and solder the wires together, then put some heatshrink over them. Perhaps you can’t clear them bc you simply unplugged them and the system sees that as a persistent sensor fault?

[tryingtobebest]

Originally Posted by ///Mobbin

For my front and rear pad sensors I cut them off and solder the wires together, then put some heatshrink over them. Perhaps you can’t clear them bc you simply unplugged them and the system sees that as a persistent sensor fault?

It is NOT the case, the sensors were good, but i still did soldering method and will try to def.code DSC again and if not ill add $2VB back to FA and then try to code DSC...
Hope this work (friends car with limited access for me)