|
|
12-04-2017, 11:04 AM | #23 |
Private First Class
40
Rep 117
Posts |
This sounds more and more doable as you guys keep giving me details and tips.
The one thing that I'm having a hard time imagining is where the bolts are located on the subframe. Can someone highlight the places where the bolts are located? Last edited by ohhgourami; 12-04-2017 at 11:04 AM.. Reason: adding picture |
Appreciate
0
|
12-04-2017, 11:29 AM | #24 |
Lieutenant General
5231
Rep 10,614
Posts |
I am seeing 4 holes down each side, 3 in a row and one off to the side on the rear end. It will be pretty obvious when you are underneath looking at the bolt heads. I did it when I the rod bearings so I had the subframe down.
|
Appreciate
1
ohhgourami40.00 |
12-05-2017, 03:26 PM | #25 |
Second Lieutenant
137
Rep 257
Posts |
That should be right.. The yellow circles are the motor mount locations. The red circles are the subframe bolts. The second one down on each side are at an angle (i.e. not straight up - probably like 30deg). Thanks! S. |
Appreciate
4
|
12-08-2022, 07:25 PM | #26 |
Private First Class
13
Rep 109
Posts |
Just got a quote from Phaedrus in SF to do mine for $380, labor only. Purchased mounts from FCP. They said about 3 hours. Was surprised to receive such a reasonable quote. BMW of course quoted over $2k when they did their complementary check.
__________________
Last edited by jsport; 12-08-2022 at 09:01 PM.. |
Appreciate
0
|
12-11-2022, 04:42 PM | #27 |
Friends don't let friends ESS
3148
Rep 868
Posts
Drives: '11 Lemans Blue 6mt Harrop e90
Join Date: Dec 2020
Location: Camas, WA
iTrader: (0)
Garage List 2011 E90 M3 [9.00]
2003 Porsche 911 Turbo [9.75] 2019 BMW X5 xDrive40i [0.00] 2013 Mercedes E550 ... [0.00] |
Old thread here but new response. Don't forget the alignment after. You drop the subframe to replace those. 2k? Jeezsch.
|
Appreciate
0
|
12-12-2022, 05:51 AM | #28 |
mTekMods
2139
Rep 2,899
Posts |
Engine mounts alone from an independent repair person should be under $500. if they take more than 3 hours to do this then you need to find a new person to work on your car.
on my car with the blower on I did this in under 2 hours, all you need to do is lift the engine a bit with a engine support or pole jack and just drop the screws on the subframe dont remove anything else besides the underpanel and support shield.
__________________
2011 Frozen Black/Fox Red E90 M3 650+WHP
G-Power Supercharged First DCT to Manual Conversion Worldwide KW CS, BBS RI-A, BW Headers, Snow 2.5 |
Appreciate
0
|
12-14-2022, 08:25 PM | #29 |
Private First Class
13
Rep 109
Posts |
Correction, they quoted me wrong and said it would take about 4 hours. Also, some special tool? And said would cost $850. But they're also honest and said my mounts actually look ok and I could just leave them alone for now. I have just over 40k miles. I only took it in because BMW SF said the engine looked a little low and suggested the mounts to be replaced.
__________________
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|