|
|
|
Post Reply |
|
Thread Tools | Search this Thread |
12-18-2019, 05:46 PM | #1 |
Private First Class
22
Rep 119
Posts |
DIY - Changed pre-cat O2 sensors after CEL, now no codes, but car sluggish
So I recently changed out both my pre cat sensors (Bosch 17039) as one of them was giving me an CEL light - ended up swapping both by accident actually as I swapped the wrong side first, but I figured it was eventually needed.
Car has 58k miles. Used to drive great before, even with the CEL lgiht on, now its a bit sluggish. Noticed its a lot slower to warm up as well.. Mileage has dropped a bit (17 MPG mix vs 18.5 before) - I know sometimes the sensors take a bit to re-calibrate but its been almost 2 tanks worth of gas through it now. Any ideas? I could try to swap the good one back in but its a pain.. |
12-20-2019, 08:16 PM | #3 |
Captain
251
Rep 628
Posts
Drives: 2014 M6 Grand Coupe CP
Join Date: May 2017
Location: Kingwood TX
|
how much have you driven since the change? You can clear the adaptation and see if that helps. alternatively, your cats might have plugged up a bit in which case you should try an Italian tuneup (a high speed full load blast or two...)
__________________
F06 M6 Grand Coupe CP
Sapphire Black Metallic The drive is the destination |
Appreciate
1
wfdeacon881104.00 |
Post Reply |
Bookmarks |
|
|