BMW M3 Forum (E90 E92)

BMW Garage BMW Meets Register Search Today's Posts Mark Forums Read

Go Back   M3Post - BMW M3 Forum > E90/E92 M3 Technical Topics > Coding / ConnectedDrive / Audio-Video / Electronics / Bluetooth / I-Drive & Nav
INDustry distribution
Post Reply
Thread Tools Search this Thread
      12-02-2012, 03:04 AM   #1
Native Texan

Drives: when at all possible
Join Date: Aug 2011
Location: Tx

iTrader: (25)

P3 vent gauge installation

The more I work on my car, the more I appreciate the attention to detail BMW takes with small things. The flap in the back of the vent that allows/prevents air flow has a rubber gasket surrounding it so that when the air is sealed off, it's sealed OFF. That being said, when installing the P3 gauge, the install instructions indicate to "Feed the cable from the display through the vent and out the rear left side. The cable is flat as not to interfere with the vent functions and exit through the back of the vent without any cutting." In doing that, I notice a) the cable, no matter what I do will not remain flat and b) the door doesn't seal properly when closed. I'm thinking about cutting the bottom of the vent, routing the cable through the hole, then sealing it w/hot glue. Has anyone else installed it that way?

Edit: n/m, found my answer here.

Last edited by whats77inaname; 12-02-2012 at 11:00 AM.
Appreciate 0
Post Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 03:10 PM.

Powered by vBulletin® Version 3.7.0
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.,,,,,,,,, logo and trademark are properties of BIMMERPOST