Euro mdm coding help

[no torque]

Hi everyone, I just coded my car with NCSexpert/dummy to access euro MDM mode. I have noticed slightly more slip angle but nothing too significant and so now I'm concerned that I didn't get all the parameters correct. Can someone who has done this diy before tell me if I have modified all the parameters correctly? My car is an 09 E92 6MT. Below I have listed all the parameters in my DSC module after I did the coding for euro MDM:


RPA
nicht_aktiv

MSA
nicht_aktiv

M3_BAUART
wert_03

M3_GETRIEBE
wert_00

M3_UEBERSTEUERN_MUE_0
wert_02
wert_06
wert_07

M3_UEBERSTEUERN_MUE_1_2
wert_02
wert_06
wert_07

MDYNAMIC_ MODE USA
nicht_aktiv

M3_PRE_MSR
nicht_aktiv

LENKWINKELKENNLINIE
wert_02
wert_03

LAT_EBD
nicht_aktiv

US_VEHICLE
nicht_aktiv

POHO
nicht_aktiv

DDS_PLUS
nicht_aktiv

ABSCHALTBARKEIT_DSC
aktiv

DRUCKMODELL_HA
wert_00

FDRUCKMODELL_VA
wert_00

If anyone could chime in with some experience/knowledge, that would be greatly appreciated!

[patroklai]

Did you follow the thread with the detailed instructions on this mod?

Overall your settings look correct but I would say you'd want to check against the "official" thread.

I can link it if needed.


Note: I tried this mod last year and for some reason it failed in my car. Haven't tried since.

[no torque]

Originally Posted by patroklai

Did you follow the thread with the detailed instructions on this mod?

Overall your settings look correct but I would say you'd want to check against the "official" thread.

I can link it if needed.


Note: I tried this mod last year and for some reason it failed in my car. Haven't tried since.

Please send the link over if possible! Ill check it over and see if the parameters match, thank you!

[patroklai]

https://www.m3post.com/forums/showthread.php?t=1481852