|
|
10-14-2019, 01:59 PM | #1 |
Private First Class
41
Rep 167
Posts |
Carbon turn signals loose
Good morning everyone,
I was wondering if anyone has had the same issue as me, PO purchased aftermarket carbon fiber turn signals. The tabs on them seem to be too thin to latch when in place, so if I take a corner hard they will fall out. PO decided to glue the passenger side in place and did a terrible job of it. I was thinking of just adding some duct tape to the tabs to make them thicker if you will to stay in place while not being glued permanently. Anyone else have any better ideas? Link to them on EAS. https://europeanautosource.com/ind-c...mw-e9x-m3.html |
10-15-2019, 10:10 AM | #2 |
New Member
9
Rep 24
Posts |
I had the same ones and my passenger signal came off on highway. Had same issue, one was loose. i replaced them with color matched ones that fit like stock.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|