|
|
12-01-2018, 04:00 PM | #1 |
Major
433
Rep 1,286
Posts |
Do88 DCT cooler question
For those of you who have the Do88 DCT cooler, where did you relocate the TPMS sensor, or did you? The instructions don't say anything about moving the sensor but if you leave it in the original location it will be rubbing on the backside of the cooler. If you lay it down sideways with the connector fitting toward the inside of the car, there isn't quite enough room between the lower engine cover felt and the bottom of the DCT cooler.
Can the TPMS be moved so that it's aiming at the tire diagonally and still pick up the signal (all the sensors are oriented right in front of the tread normally). Interested in what others have done. Otherwise installation is all done. Thanks |
12-01-2018, 04:19 PM | #2 |
Lieutenant Colonel
4100
Rep 1,612
Posts |
The newer cars don't have the tpms in the front , mine doesn't (13).
Just move it anywhere it's safe and give it a shot, should work just fine Like above the cooler or such |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|