Sponsored by The Tire Rack

[ARPHOTO]

Looking for pics of the following setup:

OEM ZCP 359M wheels
Front: 19x9, 265/30R19
Rear: 19x10, 285/30R19


Tried searching high and low to no avail. I have a pair of 265/30s sitting around and I'm wondering if they'd be alright on the 19x9 ZCP front wheels. Of course 285/30 will fit the 19x10 rears since that's the OE spec for the M3 GTS. I know 265 is a bit wide on a 9" wheel, but it falls within the acceptable width range. Thanks in advance!

[ARS18]

The 265/30 is going to look like a rubber band and have terrible ride quality if that’s a concern. Sorry I can’t help with pics. I do have pics of the 285/30 rears if interested.

[ARPHOTO]

Originally Posted by ARS18

The 265/30 is going to look like a rubber band and have terrible ride quality if that’s a concern. Sorry I can’t help with pics. I do have pics of the 285/30 rears if interested.

You're right about that, ride quality isn't great; I had them mounted to my 19x10 Forgestar F14s on the front axle for a little while and they were definitely firm. It's a long story but the tires are a few years old, I couldn't find a pair of PS4S 275/30s at the time. They've been sitting around, I might as well use them before they start dry rotting. I figure on a 19x9 they might ride okay compared to being stretched on a 19x10.

[ez2c]

255/35 275/35 will fill in the gap quite nicely

[ARPHOTO]

Originally Posted by ez2c

255/35 275/35 will fill in the gap quite nicely

I know, it's just that I have a pair of 265/30s sitting around and might as well use them.

[PYE46M3]

Originally Posted by ARS18

The 265/30 is going to look like a rubber band and have terrible ride quality if that’s a concern.

I don't think it makes that much of a difference with 265 to be honest. With 245/30 for sure but 265/30 is only 7mm thinner on the sidewall compared to OE 245/35. Overall diameter is half inch smaller.

[ARPHOTO]

Bumping. Seems like nobody has done it, I might end up being a pioneer by trying out this fitment...