engel eye not work

[yauchun8033]

Engel ring light not work at right side any solution guys

[codinge90]

Originally Posted by yauchun8033

Engel ring light not work at right side any solution guys

I recommend searching this online before posting as you're going to get roasted on this question.

#1. Check the bulb, swap from one side to the other see if it follows. If it follows then your bulb is bad, replace bulb (h8)

#2. If the swap bulbs and it stays on the not working side then it could be your ballast as those have a tendency to go out.

#3. Buy a diagnostic tool, scan the frm and see if you are throwing a short circuit fault. If so, then you need to reset it via tool32 to reset the counter to get it to power on.

[Siajoon]

I sense some trolling going on here

[IanMan]

Originally Posted by Siajoon

I sense some trolling going on here

The guy is from Malaysia and English is probably not his first language. Give him a break.

[yauchun8033]

Originally Posted by IanMan

The guy is from Malaysia and English is probably not his first language. Give him a break.

em

[yauchun8033]

Originally Posted by codinge90

I recommend searching this online before posting as you're going to get roasted on this question.

#1. Check the bulb, swap from one side to the other see if it follows. If it follows then your bulb is bad, replace bulb (h8)

#2. If the swap bulbs and it stays on the not working side then it could be your ballast as those have a tendency to go out.

#3. Buy a diagnostic tool, scan the frm and see if you are throwing a short circuit fault. If so, then you need to reset it via tool32 to reset the counter to get it to power on.

can i using the launch x431 to reset the frm？

[codinge90]

Originally Posted by yauchun8033

can i using the launch x431 to reset the frm？

No idea I don't know that software. Do the first two steps before you try to reset the frm

[yauchun8033]

Originally Posted by codinge90

No idea I don't know that software. Do the first two steps before you try to reset the frm

yep already done but problem still got

[codinge90]

Find a code reader and see if the frm is throwing a short circuit fault