SOLD: Turner Motorsport Aluminum Skid Plate

[Fezza]

12 months old but like new - SOLD

• 3/16” thick aluminium powder coated main plate and 1/8” thick aluminium powder coated side plates
• 1018 powder coated steel tube support braces for maximum skid plate strength
• Retains factory air duct for oil cooler
• Maintains wheel liner mounting positions
• Contains all necessary stainless mounting hardware and components (OE rubber trim from the vent will need transferred)
• No modification necessary; easy to convert back to stock

Installation:

[Willaayc]

Would you ship this to Sydney?

[Fezza]

Originally Posted by Willaayc

Would you ship this to Sydney?

sure can, $50 extra anywhere in Australia

[Willaayc]

great, let me check clearances with the Harrop kit cooler lines. Will come back to you shortly

[Fezza]

Originally Posted by Willaayc

great, let me check clearances with the Harrop kit cooler lines. Will come back to you shortly

I believe the only issue will be the driver side support bracket, so you'd have to install only the passenger side one, i.e. doing away with the below red circled bolts:

[FundedbyCrypto]

Hey Fezza,

What have you decided to go to? I ended up getting a brand new OEM one and its really poorly made and is stupidly expensive for what it is.

[FundedbyCrypto]

Originally Posted by FundedbyCrypto

Hey Fezza,

What have you decided to go to? I ended up getting a brand new OEM one and its really poorly made and is stupidly expensive for what it is.

Put it this way this one is superior in every way and is over $400 cheaper!

[Fezza]

Originally Posted by FundedbyCrypto

Put it this way this one is superior in every way and is over $400 cheaper!

then sell your OEM one and buy this I went with the 1 piece mporium version.

[Willaayc]

Originally Posted by Fezza

I believe the only issue will be the driver side support bracket, so you'd have to install only the passenger side one, i.e. doing away with the below red circled bolts:

Thanks for the heads up on the support bracket. Saved me some time trying to figure out if it'll fit. Would you know if using the original wire support will work on the driver side?

[Fezza]

Originally Posted by Willaayc

Thanks for the heads up on the support bracket. Saved me some time trying to figure out if it'll fit. Would you know if using the original wire support will work on the driver side?

yes that's what some people have done (https://www.m3post.com/forums/showpo...1&postcount=18) but honestly there are so many screws holding it together it'll most likely hold just fine without the 2 bracket screws.

[StavrosV]

Wish I noticed this was available