|
|
|
Post Reply |
|
Thread Tools | Search this Thread |
02-13-2017, 07:07 PM | #1 |
Major
347
Rep 1,455
Posts
Drives: E92 M3 | E90 330i
Join Date: Mar 2013
Location: Chicago, IL
|
Featured on BIMMERPOST.com So i am at 55miles with Stock Xpipe, no CEL and no Tune. All reads ready except for AIR - Secondary air system monitor and EVA - Evap system monitor. CODES P0001 - Fuel volume regulator control Circuit/Open U0001 - High speed CAN communication BUS B0001 - Driver frontal stage 1 Deployment control (subfault) C0001 - TCS Control channel "A" Valve 1 (Subfault) Would i pass if i go in?
__________________
RAE30 BUILD THREAD: http://www.e90post.com/forums/showthread.php?t=895608 Instagram: @m3whip |
02-13-2017, 11:03 PM | #2 | |
Captain
470
Rep 988
Posts |
Quote:
I'm assuming you had the challenge xpipe plus tube but now you put the stock xpipe back on and flashed back to stock tune. I'm in the middle of the same thing. Just swapped my xpipe for one with oe cats and switched ESS tune to stock. I was able to get the 20 to 30 mph and 40 to 60 cycles to turn it's corresponding monitors on by just gently driving around not letting rpm get past 3k. And that's with stopping for stop signs and stoplights... but when I ran my scanner those monitors where ready. I got secondary air to go to ready by letting it idle cold (engine doesn't just need to be cold... needs to actually sit overnight for 8 hours) then let it idle for a few minutes cold and it set the monitor on. I still have evap to turn on... maybe a couple more cold AM starts will do it. But I'm not too worried because I think California let's the evap be the only monitor not working. (Can anyone in socal verify?) You need to see how many monitors your state requires. Some allow 2 to be off some allow zero. I think since 2015 California allows evap to be off. |
|
Appreciate
2
aus891.50 Locksmythe48.00 |
02-14-2017, 08:26 AM | #3 | ||
Major
347
Rep 1,455
Posts
Drives: E92 M3 | E90 330i
Join Date: Mar 2013
Location: Chicago, IL
|
Quote:
I got the AIR to go ready now. I still have the EVA not ready though. I'll have to check if illinois requires EVA
__________________
RAE30 BUILD THREAD: http://www.e90post.com/forums/showthread.php?t=895608 Instagram: @m3whip |
||
Appreciate
0
|
02-14-2017, 12:09 PM | #4 |
Major
347
Rep 1,455
Posts
Drives: E92 M3 | E90 330i
Join Date: Mar 2013
Location: Chicago, IL
|
I got the AIR to go ready now. I still have the EVA not ready though.
__________________
RAE30 BUILD THREAD: http://www.e90post.com/forums/showthread.php?t=895608 Instagram: @m3whip |
Appreciate
0
|
02-15-2017, 04:17 PM | #5 |
First Lieutenant
48
Rep 378
Posts |
As you can see from the drive cycle instructions, EVA is set by letting the car idle after a long drive before you shutdown. It says to leave in gear.
|
Appreciate
0
|
02-15-2017, 04:19 PM | #6 | |
Major
347
Rep 1,455
Posts
Drives: E92 M3 | E90 330i
Join Date: Mar 2013
Location: Chicago, IL
|
Quote:
Thanks
__________________
RAE30 BUILD THREAD: http://www.e90post.com/forums/showthread.php?t=895608 Instagram: @m3whip |
|
Appreciate
0
|
02-15-2017, 11:28 PM | #7 | |
Major General
892
Rep 9,032
Posts |
Quote:
.
__________________
Let me get this straight... You are swapping out parts designed by some of the top engineers in the world because some guys sponsored by a company told you it's "better??" But when you ask the same guy about tracking, "oh no, I have a kid now" or "I just detailed my car." or "i just got new tires."
|
|
Appreciate
0
|
02-16-2017, 10:48 AM | #8 |
First Lieutenant
48
Rep 378
Posts |
I read a different set of instructions that had NOT said leave in gear, so I didn't. passed emissions after doing this cycle twice, 50 miles on the clock.
|
Appreciate
0
|
02-17-2017, 10:24 AM | #9 | ||
Major
347
Rep 1,455
Posts
Drives: E92 M3 | E90 330i
Join Date: Mar 2013
Location: Chicago, IL
|
Quote:
__________________
RAE30 BUILD THREAD: http://www.e90post.com/forums/showthread.php?t=895608 Instagram: @m3whip |
||
Appreciate
0
|
02-17-2017, 10:25 AM | #10 | ||
Major
347
Rep 1,455
Posts
Drives: E92 M3 | E90 330i
Join Date: Mar 2013
Location: Chicago, IL
|
Quote:
__________________
RAE30 BUILD THREAD: http://www.e90post.com/forums/showthread.php?t=895608 Instagram: @m3whip |
||
Appreciate
0
|
02-17-2017, 07:13 PM | #11 |
Major
347
Rep 1,455
Posts
Drives: E92 M3 | E90 330i
Join Date: Mar 2013
Location: Chicago, IL
|
Finally!!
__________________
RAE30 BUILD THREAD: http://www.e90post.com/forums/showthread.php?t=895608 Instagram: @m3whip |
Appreciate
1
PandaM3470.00 |
02-19-2017, 03:55 PM | #12 |
Major General
892
Rep 9,032
Posts |
What did you have to do to clear the last code?
.
__________________
Let me get this straight... You are swapping out parts designed by some of the top engineers in the world because some guys sponsored by a company told you it's "better??" But when you ask the same guy about tracking, "oh no, I have a kid now" or "I just detailed my car." or "i just got new tires."
|
Appreciate
1
m3whip347.00 |
02-19-2017, 04:10 PM | #13 |
Major
347
Rep 1,455
Posts
Drives: E92 M3 | E90 330i
Join Date: Mar 2013
Location: Chicago, IL
|
I cruised on the highway at light throttle (not past 3k rpm) at a speed of 50-65mph for 15 minutes. I made sure the gas cap was tight and the fuel tank was 1/4 to 3/4 full.
__________________
RAE30 BUILD THREAD: http://www.e90post.com/forums/showthread.php?t=895608 Instagram: @m3whip |
Appreciate
1
aus891.50 |
03-03-2017, 10:06 PM | #14 |
First Lieutenant
78
Rep 398
Posts |
drive it cold for 15mininutes keep rpms below 3000rpm , drive 40-60 mph keep rpms low , worked for me . after resetting battery.
__________________
09 Jerez black coupe . 275/35/19 mss rear,Alex alpine gts dct software with some coding(euro mdm,DVD in ,mirrors fold on lock ) , rogue engineering pulleys ,TTFS TUNE . Eibach springs . New brake front rotors with new hawk pads no rear pads. Rd front sway bar.ACTIVE AUTOWERKE TEST PIPES .csf dct cooler ,BE BEARINGS/BE ARP BOLTS,vibra road e/mounts
|
Appreciate
1
m3whip347.00 |
Post Reply |
Bookmarks |
|
|