27B0 will not go away!!!

[sumtingwong]

Originally Posted by Scrippy

So I replaced the intake hose and sensor to the secondary air pump part#11727838504. The same error came up along with another which I attribute to leaving my iPhone plugged into the snap in adapter and it drawling power charging the phone. Here is the error from INPA and its calling out bank 1 valve being stuck. I replaced both valves and hose, so Im tripping out here. I scoped the ports when I replaced and both were clear. Can I turn on the secondary air pump with INPA? I would like to do this to check the air flow if possible. Here are the translated errors...lf I was to remove the outgoing Y-hose from the pump and start the car wouldn't I get back flow from the engine exhaust if the valve was stuck open?

27B0 Secondary air system throughput bank 1

P0491 Air System (Bank 1) - Low flow rate

Error rate: 1
Logistics counter: 40

Mileage 376688 km
Ratio of secondary air volume from HFM to LAM 1.18 -
OBD-Secondary air system standard deviation integral maximum 0.00 kg / h
OBD-Secondary air system standard deviation intgral min 10.25 kg / h
Secondary air system Air mass ratio Bank1 / Bank2 via lambda signal 0.46 -

Shut-off valve 1 is stuck
Test conditions met

Errorcode: 27 B0 E4 04 91 01 28 B7 EE 04 B9 00 00 05 01 01
D6
================================================== ==================================

279D Power Management Battery quiscent current violation

Error rate: 2
Logistics counter: 40

1. Environmental principle
Mileage 376,480 km
Time with quiescent current 80-200 mA 552.53 min
Time with quiescent current 200-1000 mA 14.93 min
Time with quiescent current> 1000 mA 0.00 min
Distance to starting ability limit 26.16 -

2. Environment phrase
Mileage 376688 km
Time with quiescent current 80-200 mA 522.67 min
Time with quiescent current 200-1000 mA 0.00 min
Time with quiescent current> 1000 mA 0.00 min
Margin for startability limit 29.56 -

Quiescent current higher than allowed
Test conditions met

Errorcode: 27 9D 48 00 00 02 28 B7 D4 00 25 00 01 00 00 21
7C B7 EE 00 23 00 00 00 25 D5

So I swapped my primary O2 sensors and my code remained the same. Also swapped out brand new donut gaskets as well while I was under there. Curious, since we're both from CA, are your monitors all not showing ready? I can't get my O2 and Secondary air monitors to show ready and assuming it's because of my pending code 27B1.

[waldron80]

27b0...Oh how I know this code well. Chased it for so many years. Finally had it coded out.

I believe this is a result of carbon build up in the ports that you really can't fix without removing lots of stuff.

[Scrippy]

Originally Posted by waldron80

27b0...Oh how I know this code well. Chased it for so many years. Finally had it coded out.

I believe this is a result of carbon build up in the ports that you really can't fix without removing lots of stuff.

Yeah I scoped them when I did the valves but honestly I'm not a mechanic so I'm leaning towards this or my cat.