|
|
07-07-2019, 03:41 PM | #1 |
New Member
1
Rep 8
Posts |
Where do these wire connect to?
I am getting finished rebuilding my 2008 M3's engine, and I cant find where a few of these wires connect to. There are 2 wires, one on each side of the engine , about the same length. I cant find any connectors that they can hook to, so I think I may be missing something. Does anyone know what these sensors are for, and what they hook to? Thank you
Last edited by richie324; 07-07-2019 at 03:48 PM.. Reason: Picture didnt upload |
07-07-2019, 07:16 PM | #4 |
Lord Scrip
1813
Rep 3,013
Posts
Drives: 2011 M3 Coupe
Join Date: Jan 2012
Location: LA,Ca
|
Alarm I believe. That one is for the hood sensor.
__________________
|
Appreciate
1
EndOfAnEra515.00 |
07-07-2019, 08:08 PM | #5 |
Lieutenant Colonel
515
Rep 1,705
Posts |
Correct ^ anything before 03/2009 was pre-wired for the factory alarm and that is the hood switch connector.
__________________
|
Appreciate
0
|
07-07-2019, 08:21 PM | #6 |
Lieutenant General
11586
Rep 12,726
Posts |
hood open sensor. if you have the filter cowl covers removed, there isn't anywhere to mount it. you might have to plug in the sensor and duct tape it "shut" if you want the lock/unlock beep to work right.
__________________
Instagram; @roastbeefmike
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|