|
|
12-05-2010, 09:28 PM | #1 | |
Moderator
673
Rep 4,737
Posts |
Window Reset
Lost my window one-touch function after battery disconnect. Followed the procedure below and fixed the problem.
Quote:
|
|
12-06-2010, 12:12 AM | #2 |
Major General
258
Rep 5,012
Posts |
Hey man, did you have to do that on EVERY window ? In all my previous cars, it's just the driver's. And no need to 'erase initialization' if it doesn't work IMO; it's already erased when reconnecting battery .
And what else got screwed up other than the obvious (radio presets, etc)? Is a code needed for the radio/iDrive/nav? Hope not, because I was never given one. And how about seat memory function and sunroof auto open/close? On my other cars you needed to run seats all the way to the front and back before being able to store a seat memory. And you had to run driver's window and sunroof open and close just once to activate the auto functions. Freaking Germans have to make everything more complicated . Also wonder about BMW assist, bluetooth pairing, iDrive settings (M button, etc), and the 6 programmable (touch) buttons. When I remove mine in a year or two (to get a new one), will definitely try the 9V battery gizmo I have to avoid losing presets and such, but doubt it works on this car that everything runs with ignition off. Didn't work on my Lexus cars either since nav tried to run when the 12V adaptor was inserted, and obviously overwhelmed the little 9V battery. Resetting everything on iDrive is a royal PITA; it happened to me once when the freaking car decided to reset everything one morning (all AM/FM/XM presets, all 6 touch-button presets, seat memories, key settings, all vehicle settings, M button settings, NAV settings/history/etc... everything). Hope I don't have to do that ever again . Last edited by JCtx; 12-06-2010 at 12:27 AM.. |
Appreciate
0
|
12-06-2010, 12:17 AM | #3 |
Moderator
673
Rep 4,737
Posts |
only my driver's side window lost its one-touch close function. my seat memory was also lost. i only performed the reinitialization procedures on the window. have not tried the seat memory yet.
|
Appreciate
0
|
09-16-2015, 09:01 AM | #5 |
Captain
260
Rep 955
Posts |
The easiest way to perform this is via INPA.
There is a button under the FRM module to reset the window regulators. Down they go, back up they go and your all done. |
Appreciate
0
|
08-20-2020, 08:53 PM | #6 |
Registered
0
Rep 1
Posts |
Terminal R
The key (pardon pun) to this procedure is to insert the key into the slot below the start button and DO NOT press the start button, that puts you into Terminal R mode, asked them the rest of the procedures work like a charm.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|