|
|
02-09-2014, 10:43 AM | #1 |
Brigadier General
311
Rep 3,675
Posts |
Brake Cooling Help!!!!!!!!!
ok since the rain was crazy this weekend i decided to try and put a dent in the issue i have been having....i purchased a set of APEX brake ducts from there i attached 3" hose to a aluminum 3" hose connector on the inside of the fender liner where i cut a 3" hole that leads into the fender well...so how would i bridge the 3" hose from this aluminum connector from the inside of the fender well to outside of the fender well so i can run my hose to the cooling plates...pic show below..
big thanks to 1MOREMOD for the step by step thread that got me this far
__________________
|
02-09-2014, 07:11 PM | #2 |
Major General
532
Rep 5,498
Posts |
http://www.m3post.com/forums/showthread.php?t=652779
You will need steering limiters from TMS and lots of extra ducting for when they wear out. Jason
__________________
Instagram: jellismotorwerks |
Appreciate
0
|
02-09-2014, 07:22 PM | #3 | |
Brigadier General
311
Rep 3,675
Posts |
Quote:
__________________
|
|
Appreciate
0
|
02-09-2014, 10:23 PM | #4 |
Brigadier General
192
Rep 3,633
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|