Sponsored by The Tire Rack

[digitalpersona]

running OEM 19s with new PS4S
245/35/19 f
265/35/19 r
lowered on eibachs

turner spacers
front 15mm
rear 12mm

slightly rubbing in the rear, on a small plastic tab where the bumper meets the rear quarter panel.
considering 10mm spacers instead

[Ddonz]

There soo many post. which is great, just hard for me to search through every page to see if anyone is running the exact same spec. So here is my question. Will this setup rub? and so i need spacer?

2011 m3
kw clubsport
ap racing brake system

planning for
19x9.5 et22f and 19x10.5 et 22 rear with
255/35/19f and 275/35/19f Michellin PSS
would these rub?
any spacer needed?

[O2ShootTheJ]

19x9 et 25, 255/35/19 - Michelin PSS
19x10.5 et 26, 295/30/19 - Michelin PSS

2008 E92 M3, H&R sport springs.

Will this rub?

[RomesM3]

Forgestar f14 SDC

Front 19x10 hankook Ventus v12 evo2(275/30/19)

Rear 19x11 hankook Ventus v12 evo2 (295/30/19)
*unsure of offsets*

I have a set of eibach springs and I'm wondering if it will rub when I install them?

[dnoble37]

Stock e90 m3 zip

APEX ARC-8
F: 18x9.0" ET30
285/35? RS4

R:18x10" ET25
315/30? Rival S

Im debating between 285/35 RS4 square or front 275/35 rear 315/30 rival s.

What do you think?

[m3whip]

Forgestar F14 SDC - Michelin Tires - KW HAS
19x9.5 et22 - PSS 265/30 - Max low
19x11 et25 - PSS 295/30 - Two threads left

Rub or NO Rub?

[Amirsm3]

Originally Posted by Ddonz

There soo many post. which is great, just hard for me to search through every page to see if anyone is running the exact same spec. So here is my question. Will this setup rub? and so i need spacer?

2011 m3
kw clubsport
ap racing brake system

planning for
19x9.5 et22f and 19x10.5 et 22 rear with
255/35/19f and 275/35/19f Michellin PSS
would these rub?
any spacer needed?

This is a couple weeks old, but you should be fine.

I was running 19 Volk VR G2's with the same offset in the front and a +25 in the rear (negligible in this case) with 265/285 Continentals. No spacers needed, no rub.

I was lowered on Ohlins R&T.

[Amirsm3]

Originally Posted by m3whip

Forgestar F14 SDC - Michelin Tires - KW HAS
19x9.5 et22 - PSS 265/30 - Max low
19x11 et25 - PSS 295/30 - Two threads left

Rub or NO Rub?

Why are you tires so low? lol

Rears may or may not rub. Depends on the camber setting.

[m3whip]

Originally Posted by Amirsm3

Why are you tires so low? lol

Rears may or may not rub. Depends on the camber setting.

Lol no. That's my KW HAS setting

[Amirsm3]

Originally Posted by m3whip

Lol no. That's my KW HAS setting

oh, I was like, "dafuq?"

[turbo_joe]

Originally Posted by m3whip

Forgestar F14 SDC - Michelin Tires - KW HAS
19x9.5 et22 - PSS 265/30 - Max low
19x11 et25 - PSS 295/30 - Two threads left

Rub or NO Rub?

Fronts will be fine, rears are gonna rub at stock camber on dips and bumps. Hitting the fender liner and bumper tab most likely. Both items and can be trimmed back.

[m3whip]

Originally Posted by turbo_joe

Fronts will be fine, rears are gonna rub at stock camber on dips and bumps. Hitting the fender liner and bumper tab most likely. Both items and can be trimmed back.

I guess i'm going to add more negative camber to avoid rubbing.

On more question! My car will be lowered on kw HAS tomorrow, since my forgestar f14's aren't ready yet i'll have to use my stock zcp wheels/tires with 15mm spacers up front and 12mm in the rear. Will this rub? Same setup on kwhas, max low up front and 2 threads left in the rear.

Thank you

[turbo_joe]

Originally Posted by m3whip

I guess i'm going to add more negative camber to avoid rubbing.

On more question! My car will be lowered on kw HAS tomorrow, since my forgestar f14's aren't ready yet i'll have to use my stock zcp wheels/tires with 15mm spacers up front and 12mm in the rear. Will this rub? Same setup on kwhas, max low up front and 2 threads left in the rear.

Thank you

You should be fine on the stock wheels with spacers. Not sure how low the HAS go in the rear compared to my kit (Ground Control coil conversion) but two threads left in the rear would dump the back of my car on the ground. The rear can go way lower than the front.

For reference this is a 19x11+25 rear with a 295/30-19 Pirelli Corsa (runs very wide) so its a little wider than a 295 PSS. But to run at this height I have trimmed my fender liners and bumper tabs plus running -2 camber. Here my front is all the way down on my coils and still have about 1/2" or so left on the rears.

[Geovong]

I want the same WORK Meister M1 wheels but i cannot find anyone with a 19s without rubbing issue. 18 is fine too. What is the wheel specs for your car? any rubbing issue at full lock? I been asking around but no can tell me what is the good offset with tire size without rubbing. Hope to hear from you soon. Thanks

[Rassilon]

Car: 11 E92

Wheels w/ Offsets: Stock 18s, 8.5f/9.5r

Spacers: None

Tires / Miles: Yoko Advan 08R - (F) 255/40/18, (R) 265/40/18; New Tires

Suspension: Stock

EDC Setting: Normal/Sport

Alignment: (F) -1.3 camber (R) -1.6 camber

Fender Modifications: (F) None (R) None

Rubbing?: (F) barely, mm of clearance or rubbing, depends on how hard you turn the wheel to full lock, not audible, and will report back based on fender marks later. (R) No

[jamba]

Car: E90M lowered on Swift springs; no other suspension/brake mods
Wheels: Work Brombachers

19x9.5 et27 - Michelin PS4 275/30
19x11 et21 - Michelin PS4 295/30

Rub or NO Rub?

[becausephilchow]

Originally Posted by jhoneil

Car: E90M lowered on Swift springs; no other suspension/brake mods
Wheels: Work Brombachers

19x9.5 et27 - Michelin PS4 275/30
19x11 et21 - Michelin PS4 295/30

Rub or NO Rub?

Fronts fine, rears will rub.

[jamba]

Originally Posted by becausephilchow

Fronts fine, rears will rub.

Originally Posted by becausephilchow

Fronts fine, rears will rub.

285/30 rears?

[Ngilbe36]

E90
220M 19in wheels
No spacers
Stock suspension

255/35/19 PS4S
275/35/19 PS4S

Rub or No Rub?

[Coldone]

Stock ZCP springs 19x10 ET22 F and 19x11 ET22 R want to do 275/30/19 front and 295/30/19 rear. Will I rub?

[m3boost]

Alignment numbers reflect me in the car.

19x9.5 +23
19x10.5 +23

R888
295/30/19
265/30/19

Stock CPZ EDC suspension

No rubbing at all.

[Richbot]

285/40-17 Continental ExtremeContact Sport 17x10 ET25
E90M with Stock ZCP springs, -2.5 degrees camber front, -1.8 rear

Front - Rub on rear of fender liners with a lot of steering lock
Rear - no rub