|
|
04-21-2019, 05:42 PM | #1 |
First Lieutenant
122
Rep 334
Posts |
Used exhaust wont go back together
Hi guys
So I picked up a used e90 corsa exhaust. It's in very good condition from what I can tell. However the axel pipe and muffler inlet wont slip on. It seems if I could just stretch the muffler inlet by 1-2mm, it will accept the axel pipe. Has anyone tried an exhaust tube expander or any other ideas to get them back together? Should I try taking it to a midas/meineke to get them to expand it? |
04-21-2019, 05:52 PM | #2 |
Lieutenant General
11586
Rep 12,726
Posts |
Make sure they are really clean use some wd40 on a rag or nevrdull. Try leaving the female side in the sun and put the male end on ice.
__________________
Instagram; @roastbeefmike
|
Appreciate
0
|
04-21-2019, 07:04 PM | #3 |
Captain
171
Rep 957
Posts |
This. I had difficulty installing mine as well. It's difficult without a lift and a second set of hands. With that said, if I can do it, you can it. Keep at it.
|
Appreciate
0
|
04-22-2019, 01:18 AM | #5 |
Driver
2692
Rep 2,714
Posts |
I also had a little trouble with a used corsa. Some lube and hard pushing while twisting got it in. It also helped to have one part mounted and press the other into it. Adjusting the position of the tips while keeping the pipes inserted deep enough to prevent leakage was also annoying.
|
Appreciate
1
roastbeef11586.00 |
04-22-2019, 02:07 AM | #6 |
Lieutenant General
11586
Rep 12,726
Posts |
So just lube it up and force it in deep.
__________________
Instagram; @roastbeefmike
|
Appreciate
4
|
04-22-2019, 04:23 PM | #10 |
Lieutenant
289
Rep 553
Posts |
My Akra Evo pipe was like that when I tried to mate it with my Akra angle back. Some WD40 like roast beef said and a rubber mallet got them together beautifully. Remember to push from the hips and go deep!!
|
Appreciate
0
|
04-22-2019, 05:59 PM | #11 |
First Lieutenant
122
Rep 334
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|