|
|
07-02-2020, 04:12 PM | #1 |
Captain
326
Rep 872
Posts |
Tire Question
Hello All,
Is this an example of tire graining, normal wear or something else? It's a PSC2. TIA, SJ
__________________
AA Gen 2 Lvl 2 w/Meth; MagnaFlow catless x-pipe; Dinan Underdrive Pulley; VAC Coated Bearings; ARP Rod Bolts; Oil Diverter Valve; Dinan Strut Braces; Dinan Rear Toe Links; ECS Rear Trailing Arms; MCS 2-Way NR w/700F-1000R; GC Camber Plates; AKG 75D MM & 95A TM; CAE Shifter; Titan T-S5; StopTech ST60 380mm/ST40 355mm; MFactory DS; Zebulon Splitter; Zebulon 330 Rear Wing; Gutted w/Piper Motorsports Custom Cage; OMP WRC-R Seats
|
07-02-2020, 04:38 PM | #3 |
Captain
326
Rep 872
Posts |
Thanks. I was toying around with tire pressures and ran the last session starting at 25 lbs rather than my normal starting pressure of 28 lbs. Didn't notice any improvement but noticed this wear which I hadn't noticed previously. As the day wore on my pressures had gotten higher and higher so I tried a lower starting point.
__________________
AA Gen 2 Lvl 2 w/Meth; MagnaFlow catless x-pipe; Dinan Underdrive Pulley; VAC Coated Bearings; ARP Rod Bolts; Oil Diverter Valve; Dinan Strut Braces; Dinan Rear Toe Links; ECS Rear Trailing Arms; MCS 2-Way NR w/700F-1000R; GC Camber Plates; AKG 75D MM & 95A TM; CAE Shifter; Titan T-S5; StopTech ST60 380mm/ST40 355mm; MFactory DS; Zebulon Splitter; Zebulon 330 Rear Wing; Gutted w/Piper Motorsports Custom Cage; OMP WRC-R Seats
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|