What kind of screws??

[Slanski62]

I bought some black delrin plates from ECS to attach to the bottom of the front bumper cover. They go on the outer edges and they protect the cover from scrapes, etc. my question is, what kind of fastener do I use to attach them? They came with 3M double sided tape, but there’s also a pre drilled hole for a screw. Should I use a bolt through the bumper panel with a nut on the back side? A self tapping screw without a nut? Something else?

Your advice is very much appreciated?

[thompsac25]

Either/or would work. I used self tapping screws to secure my front lip and splitter. Has held up fine no problems. Bolt and nut would probably be more secure I'd imagine.

[Slanski62]

Thanks for your reply.