|
|
07-11-2014, 04:48 PM | #46 |
Private First Class
24
Rep 126
Posts |
Question: Is the rear lower control arm eccentric fastener mainly to adjust the alignment of the wheel, or shall I say, wheel position. It is NOT specifically there to give you camber adjustability although playing with it does affect camber? Has anyone rotated it completely to see what the affects are with alignment settings always correcting toe before the measurement of course?
The reason why I am asking is because my right rear wheel is forward about 4-5mm compared to the left. I really hope I can get it back to where it should be just by playing with these two eccentric fasteners. |
Appreciate
0
|
07-29-2017, 12:40 PM | #47 |
Private First Class
29
Rep 150
Posts |
I dont understand half of what that paper says.
When I go to the alignment shop that uses lazer alignment, this is the numbers that pop out. Front left camber, Front right camber. degrees rear left canber , rear right camber. front left toe , front right toe, then the total of the toe added (cause one side can be negative) Its all in Millimeters. Not sure its toe or something else, but its in millimeter. rear left toe, rear right toe, then the total of both added. Can someone help me to read what that paper on the first page says about the stock number on all of these? (total 8 numbers) |
Appreciate
0
|
01-02-2018, 11:13 AM | #48 |
Registered
0
Rep 1
Posts |
I want say Nice, where did u do it? and cry on
__________________
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|