|
|
11-25-2013, 04:51 PM | #266 |
-
11809
Rep 23,186
Posts |
|
Appreciate
0
|
12-02-2013, 06:29 PM | #267 |
Admiral
936
Rep 3,884
Posts |
Edit: Found someone.
__________________
2020 FORD RAPTOR 2014 F15 X5 | M-SPORT SOLD 2011 SG E90 M3 | 2008 AW E90 M3 | 2004 E46 M3 Last edited by M3ANMACHINE; 12-02-2013 at 06:37 PM.. |
Appreciate
0
|
12-02-2013, 06:36 PM | #268 | |
Admiral
936
Rep 3,884
Posts |
Quote:
__________________
2020 FORD RAPTOR 2014 F15 X5 | M-SPORT SOLD 2011 SG E90 M3 | 2008 AW E90 M3 | 2004 E46 M3 |
|
Appreciate
0
|
12-09-2013, 10:39 PM | #269 |
Lieutenant
37
Rep 549
Posts |
I just putted my Apex EC-7 18x10 ET25 Front and 18x11 ET25 rear with 275 35 18 Front and 285 35 18 Rear RS3's on my car, and i think i will need to add at least 5mm spacer to front, because i think the front tires are just rubbing my kw clubsport spring.
|
Appreciate
0
|
01-20-2014, 08:35 AM | #270 |
Enlisted Member
6
Rep 46
Posts |
Car: 2010 M3 Sedan
Wheels w/ Offsets: (F/R) ARC EC-7 18x10+33 Spacers: (F) 5mm, (R) 10mm Tires / Miles: Michelin Pilot Super Sport (F/R) 285/35/18 Suspension: Stock EDC Setting: N/A Alignment: (F) OE specs, alignment pin pulled (R) OE specs Fender Modifications: (F/R) None Rubbing?: Slight rubbing on front fender at full steering lock for the first few days; no rubbing now. Notes: The front wheel wells are perfectly filled. There is ~3mm clearance at the strut. For the street this is perfect, but racing conditions might rub due to bearing and tire deflection. With -2* front camber and +25, a 295 should fit in the front. The rears have ample room-- probably another 15-20mm of room, in fact. |
Appreciate
0
|
01-23-2014, 06:53 PM | #271 |
New Member
0
Rep 16
Posts |
(edit 2/13/2014: correction front offset)
Car: 2012 M3 E93 Wheels w/Offsets: Dinan Spec BBS CH-R 19x9.5 et 35 / 19x10.5 et 25 Spacers: None Tires: Michelin Pilot Super Sport (F) 265-30-19 (R) 295-30-19 Suspension: Dinan S-1 pkg EDC Setting: All settings Alignment: Dinan spec Fender Modifications: (F) None (R) None Rubbing?: (F) No (R) YES Comments: this modification just completed, some rubbing in the rear, mostly focused on Driver's side when going over large bumps, seems to be tolerable with 1-2 passengers, going to EDC Normal mode from Comfort improves resistance to rub, noticed Pilots have larger "tread width" measurement compared to other brands for same size (very square), tires rubbing on outside edge of tread, maybe another brand would not rub Last edited by dave2u; 02-13-2014 at 07:45 PM.. |
Appreciate
0
|
01-23-2014, 11:41 PM | #272 |
Lieutenant Colonel
208
Rep 1,581
Posts |
Hope this helps someone in the future as I did research and read a lot of reviews saying it would rub, obviously people who have never tried.
Car: e92 m3 Wheels w/ Offsets: (F/R) 19x10 et25 zcp's all around Spacers: (F) n/a, (R) 12mm Tires / Miles: Bridgestone Pole Position S04's(F) 265/35/19 (R) 275/35/19 Suspension: Lowered on SWIFT springs EDC Setting: N/A Alignment: (F) OE specs (R) OE specs Fender Modifications: (F/R) None Rubbing?: Not even close on all 4 corners. Comments: I could easily do 275 in the front, and 295 in the rear... or 10mm spacer in front, 15 in rear
__________________
2017 DG F85 X5M(current)
2016 MW ZCP F80 M3(sold) 2016 SO ZCP 6MT F82 M4(sold) 2015 MW 6MT F80 M3(sold) Individual Hellrot ZCP E92 M3(sold) |
Appreciate
0
|
01-25-2014, 07:50 PM | #273 |
Admiral
936
Rep 3,884
Posts |
So what size spacers will be needed to run 18x10 +25 with 275/35 RS3's with KW Clubsports?
TIA!
__________________
2020 FORD RAPTOR 2014 F15 X5 | M-SPORT SOLD 2011 SG E90 M3 | 2008 AW E90 M3 | 2004 E46 M3 |
Appreciate
0
|
02-03-2014, 03:11 PM | #274 |
Admiral
936
Rep 3,884
Posts |
Anybody running KW clubsports with 18x10 +25 up front and 275/35 Hankook RS3's...?
__________________
2020 FORD RAPTOR 2014 F15 X5 | M-SPORT SOLD 2011 SG E90 M3 | 2008 AW E90 M3 | 2004 E46 M3 |
Appreciate
0
|
02-12-2014, 10:55 PM | #275 | |
Lieutenant
168
Rep 548
Posts |
Quote:
__________________
991.1 GT3
SOLD: e92 M3 6MT, Jet Black/Black Dinan: Software Tune | CF Intake | Exhaust | Pulley Kit | Stage 1 Suspension | Pedals /// BBS e88 18x9.5 et19; 18x10.5 et19 on PS4 265/285 /// Lux Angel Eyes |
|
Appreciate
0
|
02-13-2014, 08:51 AM | #276 |
New Member
0
Rep 16
Posts |
Tire sizes/wheels were recommended by Dinan staff (HQ) when I got the S-1 performance pkg installed. When I picked up the car, after installation, the tech told me about a "little rubbing... only rarely"-- amazingly enough the shop manager also pointed me to a small note on the website which claimed there may be some interference in some cases (I wish they had said that up front!).
Anyway, I have a few more miles on the setup and found that by setting the EDC in NORMAL mode, the rubbing has pretty much stopped for all conditions. The ride is obviously a bit stiffer and I am not sure what will happen if I have more than two people in the car... but I do like the handling, feels sticky, flat and still crisp. Will send along a few pics shortly... Cheers! |
Appreciate
0
|
02-13-2014, 04:54 PM | #277 |
New Member
0
Rep 16
Posts |
Attached photos of the wheels/tires (apologize for the dirt/grime, it finally decided to rain in NorCal )
You can see the tires do fill the wheel wells, there is no inside rubbing, but in the pic of the isolated driver's side rear, you can see some rub marks on the outside edge of the tire. This happened in the first couple of days before stiffening the EDC setting. Close inspection indicates it is body paint from the wheel well flange, I believe from the edge where the fender and the rear bumper cover meet (but it is not obvious)... Hope this helps. Best, Dave |
Appreciate
0
|
02-13-2014, 04:59 PM | #278 | |
Major General
2760
Rep 6,735
Posts
Drives: 'E46 M3 Race Car, '23 X7
Join Date: Jan 2009
Location: Wisconsin - Instagram - @slicer_m
|
Quote:
You may want to double check your front offset. BBS does not make that wheel in a 9.5" et20. It is available in 9.5" et35 or 9" et 20 (and 8.5 et32 among other sizes). Based on your pictures, it looks like you have the 9.5" et35 version. The "Dinan Spec" CH-R's are regular CH-R's with Dinan center caps. No special size or offset for Dinan.
__________________
'23 X7
'04 M3 - Fall Line Motorsports Built Race Car - S65 swap, Dry Sump, Bosch Stand-Alone ECU, Drenth Sequential Trans, MCS 3-Way, Flossmann Wide Body, Brembo Motorsports Brakes, Drexler LSD, BBS E88 Etc. INSTAGRAM - @Slicer_M |
|
Appreciate
0
|
02-13-2014, 07:47 PM | #280 |
New Member
0
Rep 16
Posts |
Slicer,
You were correct, front offset for the Dinan spec wheels I have (Dinan part no. D750-0034-CHR-BPO) is et35 not et20. Thanks for making me aware! I have corrected the post. Cheers! |
Appreciate
0
|
02-16-2014, 08:53 PM | #282 |
Second Lieutenant
95
Rep 218
Posts
Drives: 2019 F87 M2 Competition
Join Date: Feb 2013
Location: PERTH WESTERN AUSTRALIA
|
E90 M3 ZCP
Stock ZCP rim, tyres and suspension.
With spacers front ET16, rear ET12.5 no rub.
__________________
2019 F87 M2 Competition 2021 G80 M3 Competition (sold) 2010 E90 M3 Competition (sold) 1995 E36 M3 (sold) |
Appreciate
0
|
02-21-2014, 05:27 PM | #283 | |
Lieutenant
78
Rep 490
Posts |
Quote:
I want as wide as possible on my stock ZCP. Tempted to keep the 245/35 F and do 295/30 R.
__________________
2013 M3 LMB, DCT, ZCP, Premium, EPS, Bamboo Beige, Apps, sunroof
|
|
Appreciate
0
|
02-21-2014, 11:46 PM | #284 |
Second Lieutenant
32
Rep 218
Posts |
Will I rub?
I have 19x9.5 +22 and 19x10.5 +22 TE37. I need new tires and I'm planning to get PSS 265/35/19 and 285/35/19. Will I rub with that set up and size? I am dropped a little on KW Sleeves. I am open to suggestions. Thanks!
__________________
Frozen Blue | ZCP | Akrapovic | Haimus | StopTech Trophy | Ohlins | Recaro | BBS |
|
Appreciate
0
|
02-22-2014, 12:52 AM | #285 | |
Admiral
936
Rep 3,884
Posts |
Quote:
__________________
2020 FORD RAPTOR 2014 F15 X5 | M-SPORT SOLD 2011 SG E90 M3 | 2008 AW E90 M3 | 2004 E46 M3 |
|
Appreciate
0
|
02-22-2014, 05:32 PM | #286 |
First Lieutenant
59
Rep 384
Posts |
Can anyone confirm if I'd have any issues with rubbing on the following setup?
E92 M3 on KW Sleeve 19x9.5 ET18 265/30/19 PSS 19x11 ET 25 295/30/19 PSS From my research searching this thread and other posts, it looks like I’d rub if I went 305 in the rear but should be fine with 295. I’m more questioning the fronts- 275/30 looks like I’d rub, but don’t know whether I’d be better going 265/35 or 265/30. I’m trying to avoid having to make any major camber adjustments. Thanks. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|