|
|
09-13-2013, 12:07 AM | #23 | |
Banned
85
Rep 1,236
Posts |
Quote:
|
|
Appreciate
0
|
09-13-2013, 12:42 AM | #24 | |
Second Lieutenant
17
Rep 294
Posts |
Quote:
__________________
|
|
Appreciate
0
|
09-13-2013, 12:58 AM | #25 |
Private First Class
10
Rep 156
Posts |
|
Appreciate
0
|
01-02-2014, 06:07 AM | #27 |
Banned
0
Rep 5
Posts |
|
Appreciate
0
|
09-13-2014, 06:53 PM | #30 |
Private
8
Rep 77
Posts |
nm - instructions from OP were great. Took about 2 hours, but came out good. I agree with using some extra tape, so minimize some of the gaps.
Thanks guys |
Appreciate
0
|
10-25-2014, 04:16 PM | #31 |
Private First Class
23
Rep 139
Posts |
Thanks for the write-up! Some observations from my install:
- I drilled holes through the fascia and backing trim and threaded the screw straight in. I bought edge clips but didn't bother with them and the hold seems fine (with 3m tape of course) - I bought mine used, so I'm not sure if this is a common issue. I had a couple millimeters of body color still visible behind the splitters upon installation - very noticeable on white. My solution was to get some pinstriping tape (I had a graphite color on-hand) and tape the area behind the splitter. Successfully closed up the gap! |
Appreciate
2
m3toboot23.50 XKxRome0ox1597.00 |
05-12-2016, 09:08 AM | #32 |
Lieutenant Colonel
804
Rep 1,575
Posts |
Anybody else use iPad screen protectors on the bottom like OP? I held an iPad up to my splitters and it doesn't look large enough to cover the entire area. Assuming OP used 2 screen protectors per side?
__________________
|
Appreciate
0
|
02-05-2019, 09:10 PM | #34 |
Major
1105
Rep 1,387
Posts |
Anyone know where to get just two of the front bumper hex screws to use for this? missing the two where the splitters will go and would rather not buy the entire parts kit from EAS if I need just the two hex screws.
|
Appreciate
0
|
09-25-2020, 05:54 PM | #35 | |
e90noob
1597
Rep 1,873
Posts |
Quote:
going to be installing front splitters need to order tape not going to drill an extra hole, will just use the existing 2 screws + tape edit - so the splitters i ordered ... didn't need any screws it actually did not reach the parts that have existing screws so just installed with double sided 3m tape only
__________________
2008 E90 M3 / LCI trunk + euro tail swap
Production date - 2008-04-22 Last edited by XKxRome0ox; 10-05-2020 at 06:44 PM.. |
|
Appreciate
0
|
10-04-2020, 08:28 AM | #36 | ||
Major
1105
Rep 1,387
Posts |
Quote:
|
||
Appreciate
0
|
Post Reply |
Bookmarks |
|
|