![]() |
|
|
| 06-22-2019, 01:22 PM | #9593 |
|
Lieutenant
![]() ![]() ![]() 229
Rep 487
Posts |
Did transmission fluid.
Had a notchy feeling when going from 1st gear to 2nd gear. Feels much better now. Note* I did snap off one of the bolts going to the protecting pan ![]() (One was already snapped off) I didn’t take it seriously when ista mentioned they might need to be replaced. ![]() ![]() ![]() Last edited by bmwpower603; 06-22-2019 at 04:39 PM.. |
|
Appreciate
3
|
| 06-22-2019, 03:16 PM | #9594 |
|
Colonel
![]() 3110
Rep 2,747
Posts |
Bought this ashtray gauge pod from a forum member.. it was painted white professionally but it didn't match my whip so I sanded it and painted it wrinkle black. One gauge is gonna be for diff temp, one for water temp for air to water intercooler for S/C and not sure what to make the third, any suggestions? I already have an awron gauge for boost and everything else but don't wanna leave an empty hole. Also installed temp sensor in differential.
__________________
9ers
|
|
Appreciate
1
XKxRome0ox1631.50 |
| 06-22-2019, 03:22 PM | #9595 | |
|
Driver
2708
Rep 2,715
Posts |
Quote:
__________________
E90M 6MT Slicktop Single Humper in need of a diet
|
|
|
Appreciate
0
|
| 06-22-2019, 10:53 PM | #9598 |
|
Major
![]() 367
Rep 1,005
Posts
Drives: GMC Sierra
Join Date: Jul 2012
Location: California
|
Good times. 105F and A/C worked great. Dialed up 10 clicks out on the Ohlins...and drove M240 & M340s on the track.
__________________
We grow food to feed the animals so we can eat the animals
![]() |
|
Appreciate
3
|
| 06-23-2019, 01:41 AM | #9600 |
|
e90noob
1632
Rep 1,890
Posts |
had a very productive evening
1. take off intake and plenum to reinstall plenum (hoping to get rid of an odd buzzing noise) 2. install macht schnell stage 2 intake kit (filter, air filter elbow, air scoops) 3. swap out black glossy kidney grill and install matte black kidney grill 4. clutch stop 5. finally install ZHP shift knob the intake by itself ... hard to really notice any difference except at higher rpm but intake plus valved exhaust open - much more low end growl and throaty sound clutch stop made that clutch travel super short very responsive the zhp shift knob feels great ![]() friend gave me his f80 m3 alcantra shift boot to use in my car ... it is sort of clunky for now will have to re-fit it to look a little nicer later
__________________
2008 E90 M3 / LCI trunk + euro tail swap
![]() Production date - 2008-04-22 Last edited by XKxRome0ox; 06-23-2019 at 01:50 AM.. |
|
Appreciate
0
|
| 06-23-2019, 01:48 AM | #9601 |
|
e90noob
1632
Rep 1,890
Posts |
![]() ![]() is it normal to see some oil here? when i took off the plenum today, i noticed oil in this area and 2 other spots the photo was taken after i had wiped it off ... but it was right there where the hole is... and there is a connection underneath
__________________
2008 E90 M3 / LCI trunk + euro tail swap
![]() Production date - 2008-04-22 |
| 06-23-2019, 01:54 AM | #9602 |
|
Colonel
![]() 3110
Rep 2,747
Posts |
Yes
__________________
9ers
|
|
Appreciate
0
|
| 06-23-2019, 08:52 AM | #9603 | |
|
Major
![]() 367
Rep 1,005
Posts
Drives: GMC Sierra
Join Date: Jul 2012
Location: California
|
Quote:
If you see some deals on low mileage M240s and M340s don't do it! These cars went from hot laps to shut off all day. I could hear the turbos crying. Full day sessions are full which sucks because I would like to drive a M5, but there are a lot of AM & PM 1/2 day sessions (M2-4) for M Track Days in October.
__________________
We grow food to feed the animals so we can eat the animals
![]() |
|
|
Appreciate
3
|
| 06-23-2019, 06:05 PM | #9604 |
|
Colonel
![]() 3110
Rep 2,747
Posts |
Wired up the diff gauge and water temp gauge... it's cool they go amber with the headlights on.. not bad for $55/each from prosport via ECS. I will have to get creative with how they attach to the pod itself because none of the hardware provided works with this pod.
__________________
9ers
|
|
Appreciate
0
|
| 06-23-2019, 07:02 PM | #9605 |
|
Major
![]() 367
Rep 1,005
Posts
Drives: GMC Sierra
Join Date: Jul 2012
Location: California
|
Nice displays^
Oil is draining while I am at Costco. Picked up a 36mm socket and this low profile rectangular oil drain pan from Autozone. Able to jack one side get plugs out and drop jack for even flow. FCP delivered my stuff early which is cool.
__________________
We grow food to feed the animals so we can eat the animals
![]() |
| 06-23-2019, 10:35 PM | #9607 |
|
Colonel
![]()
2795
Rep 2,188
Posts
Drives: 2011 E92 M3
Join Date: Oct 2017
Location: Victoria
|
Met up with some island M people and hung at European cars and coffee. Wonderful assortment of cars!!
__________________
![]() 2011 E92 M3 - 6MT, ZCP, ZF LSD, ESS G1, Some other goodies... |
| 06-24-2019, 04:17 AM | #9609 | |
|
Major General
![]() ![]()
5484
Rep 7,657
Posts |
Quote:
![]() |
|
|
Appreciate
1
SAMM3Y3109.50 |
| 06-24-2019, 06:23 AM | #9610 |
|
Lieutenant
![]() ![]() ![]() 422
Rep 408
Posts |
|
|
Appreciate
0
|
| 06-24-2019, 08:45 AM | #9611 | |
|
Colonel
![]()
2795
Rep 2,188
Posts
Drives: 2011 E92 M3
Join Date: Oct 2017
Location: Victoria
|
Quote:
__________________
![]() 2011 E92 M3 - 6MT, ZCP, ZF LSD, ESS G1, Some other goodies... |
|
|
Appreciate
0
|
| 06-24-2019, 09:21 AM | #9612 |
|
Major
![]()
985
Rep 1,137
Posts
Drives: 2012 E92 M3 DCT ZCP
Join Date: Nov 2015
Location: Philly burbs, PA
|
Installed an Apple Carplay emulator unit to my CIC system (bought from Alibaba), and gave her a wash yesterday.
__________________
2012 E92 M3 | ZCP | DCT | Space Grey Metallic | Black Novillo | BE/ARP | MPE V2 | do88 DCT cooler | Vorschlag | Solid SF Bushings | BMW CF Rear Spoiler, RW Carbon Diffuser, CF Front Splitters | DTEC 160W Angel Eyes
|
|
Appreciate
1
Timujin367.00 |
Post Reply |
| Bookmarks |
| Thread Tools | |
|
|