AA Signature Exhaust + ________ X-Pipe

jrxe92 · 10-26-2013, 09:16 AM

what pipe did you match your Active Autowerke Signature exhaust to? Post!

edwinm3 · 10-26-2013, 10:33 AM

Catless AA X pipe, right now I'm back to stock rear section but still catless. Got a little tired of the loud exhaust and the drone. Once I start itching again for it I'll put it back on. The sound is just bad ass, but they do tend to drone a bit specially if DCT.

THE-FN-MAN · 10-26-2013, 10:45 AM

My buddy has the aa resonated Xpipe with their signature exhaust, sounds awesome. Not sure how to post a vid from my phone because it's only allowing me to upload a pic but sounds great in person.

SouthShoreM3 · 10-26-2013, 11:10 AM

I've got the Dinan x pipe mounted. Glorious sound. Deep and then get exotic like in the higher RPMs.

Love the pairing and get tons of compliments where I live about the sound

DVG 335 · 10-26-2013, 11:51 AM

Quote:

Originally Posted by jrxe92

what pipe did you match your Active Autowerke Signature exhaust to? Post!

I had mine with the AA X-pipe with HFCs....It sounded awesome.

schnell325 · 10-26-2013, 03:22 PM

Catless AA x-pipe

C|3R1C · 10-26-2013, 04:19 PM

Catless AA. A little drone but nothing I don't love. I had the HFC version and that had less drone but those damn canisters were hanging too low so I switched out

edwinm3 · 10-26-2013, 06:09 PM

Quote:

Originally Posted by C|3R1C

Catless AA. A little drone but nothing I don't love. I had the HFC version and that had less drone but those damn canisters were hanging too low so I switched out

Yeah I had cats in the beginning also and they did sit very low.

edwinm3 · 10-26-2013, 06:10 PM

Quote:

Originally Posted by SouthShoreM3

I've got the Dinan x pipe mounted. Glorious sound. Deep and then get exotic like in the higher RPMs.

Love the pairing and get tons of compliments where I live about the sound

Does your set up drone?

SouthShoreM3 · 10-26-2013, 09:40 PM

Only below or 2k RPM.. Otherwise a set up that I will never grow tired of hearing. Thought about swapping out the AA for an essiennman race but really love this set up too much.

edwinm3 · 10-26-2013, 10:38 PM

Quote:

Originally Posted by SouthShoreM3

Only below or 2k RPM.. Otherwise a set up that I will never grow tired of hearing. Thought about swapping out the AA for an essiennman race but really love this set up too much.

SflBimmer8484 · 10-28-2013, 09:55 AM

Quote:

Originally Posted by SouthShoreM3

Only below or 2k RPM.. Otherwise a set up that I will never grow tired of hearing. Thought about swapping out the AA for an essiennman race but really love this set up too much.

jrxe92 · 11-01-2013, 09:32 AM

when u guys installed the AA muffler was there a huge eye-catching gap between the exhaust and the fender? i feel like the shop did not bring it high enough. it sits pretty low

C|3R1C · 11-01-2013, 12:08 PM

Quote:

Originally Posted by jrxe92

when u guys installed the AA muffler was there a huge eye-catching gap between the exhaust and the fender? i feel like the shop did not bring it high enough. it sits pretty low

You can adjust it yourself. I used the bottom nut on the outside hangers. Also make sure when you retighten the clamps and stuff push the exhaust up as much as possible.

gatorfast · 11-01-2013, 12:56 PM

Quote:

Originally Posted by jrxe92

when u guys installed the AA muffler was there a huge eye-catching gap between the exhaust and the fender? i feel like the shop did not bring it high enough. it sits pretty low

I had this with mine as well. No matter how much it was pushed up and re-tightened there was always too big of a gap. I just lived with it.

edwinm3 · 11-02-2013, 06:42 AM

Just had my buddies at AA re install mine. Sits perfect now.

edwinm3 · 11-02-2013, 06:44 AM

Here it is at a better angle

mike@x-ph.com · 11-02-2013, 11:53 AM

+1 for AA

SouthShoreM3 · 11-02-2013, 06:07 PM

Put a rear diffuser on and it will clear up any gaps!!! Hah!

Great work from AA in he design of this.

Owned my rear exhaust for almost 4 years coming up next May. Still looks new today this day. Granted done quite a few polishes with steel wool because those tips get caked when u got no cats!

jrxe92 · 11-02-2013, 07:39 PM

Quote:

Originally Posted by C|3R1C

You can adjust it yourself. I used the bottom nut on the outside hangers. Also make sure when you retighten the clamps and stuff push the exhaust up as much as possible.

you adjusted the height only using the outside hangars? i thought the main clamp by the mid pipes had to be re-loosened and the exhaust end had to be lifted while the clamps were re-tightened

C|3R1C · 11-02-2013, 08:37 PM

Quote:

Originally Posted by jrxe92

Quote:

Originally Posted by C|3R1C

You can adjust it yourself. I used the bottom nut on the outside hangers. Also make sure when you retighten the clamps and stuff push the exhaust up as much as possible.

you adjusted the height only using the outside hangars? i thought the main clamp by the mid pipes had to be re-loosened and the exhaust end had to be lifted while the clamps were re-tightened

Not only the outside. I loosed the whole thing then using the lowest nuts and pushing up while lining stuff up, I tightened it. I really reduced the gap

C|3R1C · 11-02-2013, 08:47 PM

Quote:

Originally Posted by jrxe92

Quote:

Originally Posted by C|3R1C

You can adjust it yourself. I used the bottom nut on the outside hangers. Also make sure when you retighten the clamps and stuff push the exhaust up as much as possible.

you adjusted the height only using the outside hangars? i thought the main clamp by the mid pipes had to be re-loosened and the exhaust end had to be lifted while the clamps were re-tightened

I also used a jack and a block if wood to push the mufflers up at the same time

10-26-2013, 09:16 AM	#1
jrxe92 Private 6 Rep 89 Posts Drives: 2009 M3 Join Date: Jun 2010 Location: Long Island, NY iTrader: (0)	AA Signature Exhaust + ________ X-Pipe what pipe did you match your Active Autowerke Signature exhaust to? Post!
	Appreciate 0 Tweet Quote

10-26-2013, 10:33 AM	#2
edwinm3 Brigadier General 1053 Rep 4,035 Posts Drives: F82 Join Date: Nov 2011 Location: Broward iTrader: (32)	Catless AA X pipe, right now I'm back to stock rear section but still catless. Got a little tired of the loud exhaust and the drone. Once I start itching again for it I'll put it back on. The sound is just bad ass, but they do tend to drone a bit specially if DCT. __________________ Grigio Telesto M4, 6MT. Coyote 5.0 F-150 991 GT3
	Appreciate 0 Quote

10-26-2013, 10:45 AM	#3
THE-FN-MAN Captain 43 Rep 890 Posts Drives: E92 M3 x2 Join Date: Feb 2012 Location: the wood iTrader: (0)	My buddy has the aa resonated Xpipe with their signature exhaust, sounds awesome. Not sure how to post a vid from my phone because it's only allowing me to upload a pic but sounds great in person.
	Appreciate 0 Quote

10-26-2013, 11:10 AM	#4
SouthShoreM3 Passes everything but the gas station 66 Rep 795 Posts Drives: 2010 E90 M3 Join Date: Jul 2010 Location: Boston, MA iTrader: (2)	I've got the Dinan x pipe mounted. Glorious sound. Deep and then get exotic like in the higher RPMs. Love the pairing and get tons of compliments where I live about the sound
	Appreciate 0 Quote

10-26-2013, 03:22 PM	#6
schnell325 Bored at work.... 1194 Rep 5,720 Posts Drives: 2016 F82 M4 GTS Join Date: Aug 2007 Location: Comox Valley iTrader: (8)	Catless AA x-pipe
	Appreciate 0 Quote

10-26-2013, 04:19 PM	#7
C\|3R1C So Kewl Guy 56 Rep 619 Posts Drives: 2010 E93 M3 DCT Join Date: Sep 2011 Location: Los Angeles iTrader: (3)	Catless AA. A little drone but nothing I don't love. I had the HFC version and that had less drone but those damn canisters were hanging too low so I switched out __________________ 2010 E93 M3 / MS Catless X-Pipe / AA Catback / Vorsteiner Vented Hood and Bootlid E93 Trunk / ADV1 7.1 Wheels GB / LS3 LED Lights / Harrop Supercharger
	Appreciate 0 Quote

10-26-2013, 09:40 PM	#10
SouthShoreM3 Passes everything but the gas station 66 Rep 795 Posts Drives: 2010 E90 M3 Join Date: Jul 2010 Location: Boston, MA iTrader: (2)	Only below or 2k RPM.. Otherwise a set up that I will never grow tired of hearing. Thought about swapping out the AA for an essiennman race but really love this set up too much.
	Appreciate 0 Quote

11-01-2013, 09:32 AM	#13
jrxe92 Private 6 Rep 89 Posts Drives: 2009 M3 Join Date: Jun 2010 Location: Long Island, NY iTrader: (0)	when u guys installed the AA muffler was there a huge eye-catching gap between the exhaust and the fender? i feel like the shop did not bring it high enough. it sits pretty low
	Appreciate 0 Quote

11-02-2013, 06:42 AM	#16
edwinm3 Brigadier General 1053 Rep 4,035 Posts Drives: F82 Join Date: Nov 2011 Location: Broward iTrader: (32)	Just had my buddies at AA re install mine. Sits perfect now. Attached Images __________________ Grigio Telesto M4, 6MT. Coyote 5.0 F-150 991 GT3
	Appreciate 0 Quote

11-02-2013, 06:44 AM	#17
edwinm3 Brigadier General 1053 Rep 4,035 Posts Drives: F82 Join Date: Nov 2011 Location: Broward iTrader: (32)	Here it is at a better angle Attached Images __________________ Grigio Telesto M4, 6MT. Coyote 5.0 F-150 991 GT3
	Appreciate 0 Quote

11-02-2013, 11:53 AM	#18
mike@x-ph.com Joint Chiefs of Staff 33142 Rep 207,716 Posts Drives: 07-335/12-328/18-M4/21-M4CP Join Date: Sep 2013 Location: Las Vegas iTrader: (23)	+1 for AA __________________ Check out our current sale by clicking on this link! https://x-ph.com/sale/ Phone number 725-221-5267
	Appreciate 0 Quote

11-02-2013, 06:07 PM	#19
SouthShoreM3 Passes everything but the gas station 66 Rep 795 Posts Drives: 2010 E90 M3 Join Date: Jul 2010 Location: Boston, MA iTrader: (2)	Put a rear diffuser on and it will clear up any gaps!!! Hah! Great work from AA in he design of this. Owned my rear exhaust for almost 4 years coming up next May. Still looks new today this day. Granted done quite a few polishes with steel wool because those tips get caked when u got no cats!
	Appreciate 0 Quote