5062 error code also 604e

[71velle]

Getting this trans error code 5062. Did a little searching but nothing definite on old posts. Anyone has encountered this code what steps were taken to fix.




Will be taking car to America's tire to see if one of the sensors is not working, low battery or if it's the receiver. This is for code 604e

Car is a 11 Comp auto.

[yardbro]

Originally Posted by 71velle

Getting this trans error code. Did a little searching but nothing definite on old posts. Anyone has encountered this code what steps were taken to fix.

Will be taking car to America's tire to see if one of the sensors is not working, low battery or if it's the receiver. This is for code 604e

Car is a 11 Comp auto.

Getting the sensors checked is a good place to start for sure. IIRC there is a service function within ISTA that will let you monitor each receiver in the wheel wells and should show the corresponding pressure and temp it is getting from each TPMS sensor within the wheels. This would be the next step if your tire shop comes back that all sensor batteries are charged and scannable so you can check what the car is seeing.

I had a problem similar to this where all receivers were reporting the same default number. I tried replacing the main antenna underneath the car, but it turned out to be the RDC module itself :/ The solution for me was to ultimately remove the module and code out TPMS.