i do not see anything bad in the pics above?! what exactly do you complain?
what made you think it does not lock anymore? do you think the preload is too low after you measured it? or is the amount of lockup too low for your application? the friction disc that can be seen looks fine. so does the outer disc although you shot it on the wrong side... the side you can see here did face the cupspring.
please tell us what exactly is scewed. i only see the marc of the cupspring, which is normal. but you can see quite well where the spring hits the disc (NOT on the outer edge but somewhere in the middle... so the load on the clutchpack is more even) and that the wear on the friction disc is perfectly even as well.
to be honest you are the first who does complain about this setup. and the pictures you provide here do not show your complains?!
also i am wondering why you did not contact me?! i just saw your post after i randomly checked m3post.
|