Quote:
Originally Posted by SYT_Shadow
Quote:
Originally Posted by jid2
I installed the BW mounts this weekend during my rod bearing install and find them seriously harsh. There is significant vibration and noise at idle and during clutch transitions (with DCT). I saw some comments about the torque on the top nut, is it possible I went too far?
|
likely they need to break in. Mine did during a couple thousand miles, although the only time they were harsh was at idle
With a raised idle I would be hard pressed to notice the difference
|
FWIW - I have them and also don't find them to be harsh (I have DCT). Something could be wrong with your install.