Quote:
Originally Posted by tlp
Finished the 2nd Phase (Wiring & Coding) ......
- Disconnect the battery
- Route the wire harness through the firewall and ran it down the passenger side foot well and door sill all of to the rear of the car.
- Replace the center console button cluster
- Installed the new PDC Module (Use the pin mapping from the Schematic and not the instructions as two of the pins are labeled wrong)
- Retrofit Coding of the car for option $508 (PDC Full)
Thanks to Tom @ EAS for providing some wire routing tips through the firewall.
It should noted that the wiring pin mapping in the attached instructions on page 27 is wrong.
- PIN 3 should map to the Brown\Black wire
- PIN 2 should map to the Brown\White wire
Random Photos taken during the install.
|
I'm not sure if you noticed after coding the front PDC that it beeps slower than the rear PDC... it was bothering me and I read through TRC and found the solution to make them beep at the same rate. The sounds are different so no confusion whether it's front or rear....
front PDC frequency: FREQUENZ_TONGEBER_VORNE - code from: wert_02 to wert_01
and if for any reason someone wants a slower beep in front and rear PDC same token code:
rear PDC frequency: FREQUENZ_TONGEBER_HINTEN code from: wert_01 to wert_02
hope that helps!